Nokia of America Corporation BBTRX-14 Benutzerhandbuch
The AC input port satisfies the first and second level surge protection requirements
specified for port type 7 in GR-1089, Issue 6. Voltage spikes with a duration of ≤10µs are
ignored.
specified for port type 7 in GR-1089, Issue 6. Voltage spikes with a duration of ≤10µs are
ignored.
The internal power module is designed such that when an “under voltage”, “over
voltage”, or “over temperature” condition occurs, the power module automatically shuts
off, then automatically restarts when the conditions are within the acceptable limits.
voltage”, or “over temperature” condition occurs, the power module automatically shuts
off, then automatically restarts when the conditions are within the acceptable limits.
Backhaul
The 9763 MCI supports two SFP interfaces for backhaul. as follows:
• 1000Base-X GigE optical transceiver
• 10/100/1000Base-T electrical transceiver
One SFP (BH1) may be cabled for backhaul to the network while the other SFP (BH2)
may be cabled for daisychaining to another 9763 MCI. Two 9763 MCIs may be
daisychained together.
• 1000Base-X GigE optical transceiver
• 10/100/1000Base-T electrical transceiver
One SFP (BH1) may be cabled for backhaul to the network while the other SFP (BH2)
may be cabled for daisychaining to another 9763 MCI. Two 9763 MCIs may be
daisychained together.
RF Antennas
The 9763 MCI contains two internal quasi-omnidirectional, spatially-separated antennas
configured for 2x2 MIMO.
configured for 2x2 MIMO.
The vertical plane half-power beamwidth (HPBW) is typically 90° for each of the
antennas
antennas
The RF antenna connectors are located externally on the rear of the unit, providing the
service provider the option of connecting the internal RF antennas or connecting two
externally cabled RF antennas.
service provider the option of connecting the internal RF antennas or connecting two
externally cabled RF antennas.
GPS Antenna
The 9763 MCI has a connector for an external GPS antenna to provide frequency and
phase synchronization.
phase synchronization.
Status indicator
The 9763 MCI supports a single bi-color LED (red/green) which is located on the rear
lower portion of the 9763 MCI. The LED is not intended for use during normal operation
of the equipment, however, it can provide a visual status of the equipment during initial
installation and commissioning. Refer to the LED interpretation table in
lower portion of the 9763 MCI. The LED is not intended for use during normal operation
of the equipment, however, it can provide a visual status of the equipment during initial
installation and commissioning. Refer to the LED interpretation table in
for details.
Hardware architecture and functionality
Physical description
....................................................................................................................................................................................................................................
....................................................................................................................................................................................................................................
Alcatel-Lucent 9763 MCI
3MN-MCI-IMOP
Issue 1
Alcatel-Lucent 9763 MCI
3MN-MCI-IMOP
Issue 1
December 2013
Alcatel-Lucent – Proprietary
Use pursuant to applicable agreements
2-5