Nokia of America Corporation BBTRX-18 Benutzerhandbuch
Powering up the device
Perform the following steps:
...................................................................................................................................................................................................
1
Test the power at the power source.
...................................................................................................................................................................................................
2
If power to the receptacle outlet has been shut off, turn it on.
...................................................................................................................................................................................................
3
CAUTION
RF hazard
Near immediately after the model is powered, it can begin to transmit RF signals and thus
becomes a potential hazard of human irradiation from that RF. Nonionizing radiation of
this kind may damage human tissue or cause other health problems, even at doses far
below those that produce perceptible heating.
becomes a potential hazard of human irradiation from that RF. Nonionizing radiation of
this kind may damage human tissue or cause other health problems, even at doses far
below those that produce perceptible heating.
For more information on the safe separation distance, see
Plug the power cord into the power source.
...................................................................................................................................................................................................
4
Begin observing and noting the changes that occur in the LED indications of the 9768
MRO.
MRO.
On the bottom of the Alcatel-Lucent 9768 MRO, a single visible LED provides local
diagnostic indications. The LED indications have specific meanings, as defined in the
following table:
diagnostic indications. The LED indications have specific meanings, as defined in the
following table:
Table 3-1
LED interpretations
If the LED is...
then the indication is that...
not lit at all
the 9768 MRO is not powered.
steady-lit green
the 9768 MRO is powered, its RF functions are enabled, and its links with the
9926 d2U Base Band Unit are active.
9926 d2U Base Band Unit are active.
blinking green
the 9768 MRO is not transmitting.
steady-lit yellow
the slave link between this 9768 MRO and the next 9768 MRO in a
daisy-chained configuration has a fault. Where a daisy chain is not
implemented (as in the initial release of this product, which does not support
daisy chaining), this LED condition will not be seen.
daisy-chained configuration has a fault. Where a daisy chain is not
implemented (as in the initial release of this product, which does not support
daisy chaining), this LED condition will not be seen.
blinking yellow
a download of firmware is occurring.
Installing an 9768 MRO B4
Procedure 3-1: Installing the 9768 MRO B4 onto a wall or
pole
....................................................................................................................................................................................................................................
....................................................................................................................................................................................................................................
3-22
Alcatel-Lucent – Internal
Proprietary – Use pursuant to Company instruction
Alcatel-Lucent 9768 MRO
3MN-MRO-AWS-IMOP
Issue 1
February 2014