Nokia of America Corporation BBTRX-22 Benutzerhandbuch
CPRI interface
There are two CPRI interface ports (labeled CPRI1 and CPRI2) on the bottom of the
Alcatel-Lucent B25 RRH4x30. Connections are made between these ports and an
Alcatel-Lucent 9926 Base Band Unit (BBU) [Alcatel-Lucent 9926 BBU]. The CPRI1
(primary) port is connected to the Alcatel-Lucent 9926 BBU and the CPRI2 (secondary)
port is reserved for future use.
Alcatel-Lucent B25 RRH4x30. Connections are made between these ports and an
Alcatel-Lucent 9926 Base Band Unit (BBU) [Alcatel-Lucent 9926 BBU]. The CPRI1
(primary) port is connected to the Alcatel-Lucent 9926 BBU and the CPRI2 (secondary)
port is reserved for future use.
The ports support CPRI Rate 3 through 5 and are hardware ready to support CPRI Rate 7.
The CPRI port connectors are SFP sockets.
Note: SFP optical transceivers and Radiall 2 Connectors to Transceiver (R2CT)
weatherized connectors are not provided with the Alcatel-Lucent B25 RRH4x30.
They must be ordered separately and are required for installation.
weatherized connectors are not provided with the Alcatel-Lucent B25 RRH4x30.
They must be ordered separately and are required for installation.
AISG interface
There is one surge-protected AISG output port on the bottom of the Alcatel-Lucent
B25 RRH4x30.
B25 RRH4x30.
The AISG output connector is an 8-pin circular DIN sockets (female pins).
Alarms interface
There is one surge-protected user alarm port on the bottom of the Alcatel-Lucent
B25 RRH4x30. The user alarms port can support up to four external user alarms.
B25 RRH4x30. The user alarms port can support up to four external user alarms.
The user alarm port connectors are 8-pin circular DIN sockets.
RF antenna interface
There are four RF TxRx ports on the bottom of the Alcatel-Lucent B25 RRH4x30.
Connections are made between these ports and an antenna or antennas.
Connections are made between these ports and an antenna or antennas.
The RF port connectors are 7/16 DIN coaxial sockets.
Note: Unused RF port connectors must have a 10 W load terminator installed, which
are not provided with the Alcatel-Lucent B25 RRH4x30. If needed, they must be
ordered separately.
are not provided with the Alcatel-Lucent B25 RRH4x30. If needed, they must be
ordered separately.
Receive monitor (RxMON) interface
There are four RF RxMON ports on the bottom of the Alcatel-Lucent B25 RRH4x30.
Connections are made between these ports and antenna receive monitoring equipment.
Connections are made between these ports and antenna receive monitoring equipment.
The RxMON port connectors are QMA coaxial sockets.
External interfaces
Description
....................................................................................................................................................................................................................................
....................................................................................................................................................................................................................................
B25 RRH4x30
3MN-02023-0001-RJZZA
Issue 0.02
B25 RRH4x30
3MN-02023-0001-RJZZA
Issue 0.02
January 2015
Alcatel-Lucent – Proprietary
Use pursuant to applicable agreements
3-5
D
R
AFT
AFT
D
R
AFT
AFT