E F Johnson Company 2424330 Benutzerhandbuch

24

4.12.2  RADIO WIDE SCAN LIST

General

With radio wide scanning, there is only one scan 

list available regardless of the type of channel selected. 
This list can include up to 16 channels of any type. For 
example, it could include six conventional channels 
and ten SMARTNET/SmartZone channels. More 
information on selecting and editing radio wide scan 
lists follows.

Determining Channels in Radio Wide Scan List

The channels in radio wide scan lists can be 

determined only by selecting the scan list edit mode 
(see “Editing Radio Wide Scan List” which follows).

When the displayed channel is in the scan list 

(scanned normally), the   symbol is displayed next to 
the zone number as shown in the following 
illustration.

Editing a Radio Wide Scan List

If the RWS ED option switch is programmed, the 

radio wide scan list can be edited. Changes are perma-
nent (cycling power does not reselect a default condi-
tion). Proceed as follows:

1. Make sure that both standard and radio wide scan-

ning are off (the rotating   icon is not indicated in 
the right status display). Select the scan edit mode 
by pressing the RWS ED option switch. This mode 
is indicated by a triangle in the upper left corner of 
the display (see Figure 2-3 on page 11.). 

2. Select the channel you want to add or delete by 

rotating the Select switch. After the last channel in 
the current zone is displayed, the first valid channel 
in the next zone is displayed and vice versa. Lists are 
limited to 16 channels. If an attempt is made to add 
more than 16, “LIST FULL” is displayed and a 
channel must be deleted before another can be 
added.

3. If the selected channel is in the scan list (scanned), 

the   symbol is displayed next to the zone number 
as just described. To change the scan list status of 
the displayed channel, press the Select switch. 

4. To exit this mode and save the changes, press the 

RWS ED option switch again.

Scan List Indicator

Chnl

No.