E F Johnson Company 2425333 Benutzerhandbuch

Parms Fail - The checksum of the profile / user parameters does not match the calculated 
checksum. This indicates that there is an error in the parameters file. This message only 
occurs if the redundant copy of the parameters is also corrupt or is unable to be used.

Rekey Fail - This error indicates a failure in a rekeying process.

Rx Only - The selected channel is Rx only.

Sts Failed - No acknowledgement was received while sending a status report.

Timeout - A time out has occurred in attempting the current function.

Too Hot - The radio has passed the TOO HOT temperature threshold. Under these 
conditions the radio will not allow Tx.

Tx Timeout - The Tx time-out timer has expired and Tx has been terminated.

VOLTAGE HI - The input voltage to the radio is too high.

VOLTAGE LO - The input voltage to the radio is too low. 

Write Fail - The radio is unable to write to the EEPROM. 

Zone Fail - The radio has been programmed with more zones than its options allow.

As noted previously, programming determines the availability and specific operation of 
many features. This usually refers to the programming performed by your system operator 
when the radio was set up, not to any programming that a user can perform. If a feature is 
controlled by a front panel option switch and that switch is not available, the feature is 
probably not available.

An exception is Keypad Programming which can allow the user to reprogram several 
conventional channel parameters. Refer to Section 5.14 for more information.

For best results, hold the microphone about 1-2 inches from your mouth and speak at a 
normal conversational level. Do not shout since it distorts your voice and does not increase 
range.