E F Johnson Company 2425372 Benutzerhandbuch
Draft
-20 5300 ES Series Mobile Radio Operating Manual
December 2006
Since keypad programming is permitted by Federal Government users only, only Federal
models of this transceiver can be programmed with this feature. It is then available only if
it has been enabled by factory programming and a conventional mode option switch is
programmed for the “Keypad Programming” function.
models of this transceiver can be programmed with this feature. It is then available only if
it has been enabled by factory programming and a conventional mode option switch is
programmed for the “Keypad Programming” function.
Keypad programming is selected by pressing the PROG option switch (password entry is
not required). The keypad programming mode is indicated by “CHNG ZONE” and a
triangle in the display as follows:
not required). The keypad programming mode is indicated by “CHNG ZONE” and a
triangle in the display as follows:
Keypad programming allows conventional channel parameters such as the transmit and
receive frequency, Call Guard squelch code, and encryption key to be changed. In
addition, several conventional mode timers can be changed. It cannot be used to reprogram
disabled channels or any P25 Trunked, SMARTNET, or SmartZone information.
receive frequency, Call Guard squelch code, and encryption key to be changed. In
addition, several conventional mode timers can be changed. It cannot be used to reprogram
disabled channels or any P25 Trunked, SMARTNET, or SmartZone information.
5.16.1 Menu Structure
A menu system is used to select parameters in the keypad programming mode. Rotate and
press the Select switch to scroll through and select the available parameters. The available
parameters and the section in which each is described are as follows:
press the Select switch to scroll through and select the available parameters. The available
parameters and the section in which each is described are as follows:
• CHNG ZONE (5.16.3)
• CHNG CHAN (5.16.4)
• SYS PARMS (5.16.5)
• CHAN PARMS (5.16.6)
Press the Select switch to select the displayed parameter. Press the PROG option switch
from one of the main menus to exit keypad programming or from other menus to exit back
one level. A flowchart showing the keypad programming mode menu structure is located
Figure 5.1. Refer to the descriptions which follow for more information.
from one of the main menus to exit keypad programming or from other menus to exit back
one level. A flowchart showing the keypad programming mode menu structure is located
Figure 5.1. Refer to the descriptions which follow for more information.