E F Johnson Company 2425372 Benutzerhandbuch
Draft
December 2006
5300 ES Series Mobile Radio Operating Manual -9
•
If five beeps sound, the system received the page and the paged mobile is on the air
and received it. The page mode is automatically exited.
and received it. The page mode is automatically exited.
•
If the system received the page but the called mobile is not on the air, a single beep
sounds and “NO ACK” is displayed 6 seconds after the PTT switch is pressed. Auto
exit then occurs.
sounds and “NO ACK” is displayed 6 seconds after the PTT switch is pressed. Auto
exit then occurs.
6.7
Messaging
Note
This feature is not available with P25 trunked operation.
The messaging feature allows preprogrammed messages to be sent to your dispatcher. Up
to 16 messages can be preprogrammed, and they are identified by an alias. If an MSG
option switch is programmed, messages are sent as follows:
to 16 messages can be preprogrammed, and they are identified by an alias. If an MSG
option switch is programmed, messages are sent as follows:
1 Momentarily press the MSG option switch. The alias of the last message sent is
displayed.
2 If required, rotate the Select switch to display the desired message. Then send the
message by momentarily pressing the PTT or Select switch. One of the following then
occurs:
occurs:
•
If five beeps sound and “ACK RCVD” is displayed, the message was received and
automatically acknowledged by the system.
automatically acknowledged by the system.
•
If after five tries the message is not acknowledged, a tone sounds and “NO ACK” is
displayed.
displayed.
6.8
Sending Status Conditions
The status feature allows you to manually or automatically send your current status to your
dispatcher. Up to eight status conditions can be preprogrammed, and they are identified by
a tag (alias). If the STATUS option switch is programmed, status conditions are sent as
follows:
dispatcher. Up to eight status conditions can be preprogrammed, and they are identified by
a tag (alias). If the STATUS option switch is programmed, status conditions are sent as
follows:
1 Momentarily press the STATUS option switch. The tag of the current status condition
is displayed.
2 To change the current status, rotate the Select switch or press the PTT switch until the
desired status is displayed. Then press the Select switch to accept that status. One of the
following conditions then occurs:
following conditions then occurs:
•
If five beeps sound and “ACK RCVD” is displayed, the status was received and
acknowledged by the system.
acknowledged by the system.
•
If after five tries the message is not acknowledged, a tone sounds and “NO ACK” is
displayed.
displayed.