E F Johnson Company 2425770 Benutzerhandbuch
5-30
Viking Portable 600 Radio Operating Manual
Conventional Mode Features
Press the <F2> (Select) button to select a highlighted parameter, and press the <F1>
button from one of the main menus to exit keypad programming. Pressing it in the other
menus returns to the previous menu. The Up/Down buttons are also used in several menus
to scroll through available selections. Additional information on this parameters is located
in the following sections.
button from one of the main menus to exit keypad programming. Pressing it in the other
menus returns to the previous menu. The Up/Down buttons are also used in several menus
to scroll through available selections. Additional information on this parameters is located
in the following sections.
5.14.2 Zone Password
Each zone can be programmed with a password to prevent unauthorized reprogramming of
zone by keypad programming. When this password is programmed, it must be entered
before system or channel parameters in that zone can be changed by keypad programming.
The zone password is programmed. A different password can be programmed for each
zone.
zone by keypad programming. When this password is programmed, it must be entered
before system or channel parameters in that zone can be changed by keypad programming.
The zone password is programmed. A different password can be programmed for each
zone.
Note
Ensure that the zone passwords are not lost because they cannot be overridden in the field.
When an attempt is made to select a system or channel parameter in a password protected
zone, “Password” is flashed. The password is always eight digits long and is entered using
the same procedure as used for the power-up password described below. After the
password is entered, system and channel parameters for that zone can be reprogrammed
normally.
zone, “Password” is flashed. The password is always eight digits long and is entered using
the same procedure as used for the power-up password described below. After the
password is entered, system and channel parameters for that zone can be reprogrammed
normally.
When this feature is enabled, “Enter Pswd” is briefly displayed when power is turned on.
The password can be 1-8 digits in length, and consists of digits 0-9. It is entered as
follows. If an incorrect password is entered, “Incorrect” is displayed and it must be re-
entered. A password of 0 deactivates the feature.
The password can be 1-8 digits in length, and consists of digits 0-9. It is entered as
follows. If an incorrect password is entered, “Incorrect” is displayed and it must be re-
entered. A password of 0 deactivates the feature.
5.14.3 Zone Change Parameter
The “Chng Zone” menu parameter selects the zone containing the conventional channel to
be reprogrammed. It does not change the zone selected for normal operation.
be reprogrammed. It does not change the zone selected for normal operation.
Press the <F2> button to select the “Chng Zone” parameter and then scroll through the
programmed zones by pressing the Up/Down buttons. When the desired zone is displayed,
select it by pressing the <F2> button.
programmed zones by pressing the Up/Down buttons. When the desired zone is displayed,
select it by pressing the <F2> button.
5.14.4 Channel Change Parameter
The “Chng Chan” menu parameter selects the conventional channel to be reprogrammed.
Disabled or SmartNet/SmartZone/P25 Trunked channels cannot be selected. This does not
change the channel selected for normal operation.
Disabled or SmartNet/SmartZone/P25 Trunked channels cannot be selected. This does not
change the channel selected for normal operation.
Preliminary Draft 3/9/12