E F Johnson Company 2425770 Benutzerhandbuch
Viking Portable 600 Radio Operating Manual
3-9
General Operation
3.4.2 Low Battery Indication
Note
If the radio contains encryption keys and is not programmed for infinite key retention, be
sure to reattach a battery within approximately 30 seconds to prevent the loss of these
keys (see following).
sure to reattach a battery within approximately 30 seconds to prevent the loss of these
keys (see following).
A low-battery condition is indicated by the
icon in the display. The battery should
be recharged or replaced as soon after this indication appears. Once this indication
appears, it stays on until power is cycled.
appears, it stays on until power is cycled.
Note
The signal strength indicator normally occupies the location used by the Low Battery
icon. If the radio enters low batty mode, the Low Battery icon takes priority.
icon. If the radio enters low batty mode, the Low Battery icon takes priority.
The following additional low battery indications and conditions may be enabled by
programming:
programming:
• A chirp sounds once a minute in the receive standby and transmit modes.
• A chirp sounds each time the PTT switch is pressed.
• The top panel LED indicator flashes red every 30 seconds in the receive mode.
• Low power is selected when transmitting.
As indicated in the preceding note, the radio may need to be connected to a constant power
source to preserve the encryption keys in memory. This is required if “infinite key
retention” is not programmed. To allow the battery to be changed without losing the keys
with this feature disabled, storage capacitors maintain the supply voltage to memory for
approximately 3.5 minutes without a battery attached. Therefore, be sure to reattach a
battery within that time. Refer to Section 8 for more information on encryption keys.
source to preserve the encryption keys in memory. This is required if “infinite key
retention” is not programmed. To allow the battery to be changed without losing the keys
with this feature disabled, storage capacitors maintain the supply voltage to memory for
approximately 3.5 minutes without a battery attached. Therefore, be sure to reattach a
battery within that time. Refer to Section 8 for more information on encryption keys.
3.4.3 Battery Charging
Note
When a battery is charged while attached to the radio, make sure radio power is off (see
following).
following).
The battery can be charged separately or while attached to the radio. When it is charged
while attached to the radio, radio power should be turned off. If it is not, the battery begins
slowly discharging when the charger enters the trickle charge mode. This mode is
indicated by a green Ready indication, and it is entered automatically when the battery is
nearly fully charged. Gradual discharging occurs in the trickle mode because the charge
current is less than the radio standby current (of approximately 200 mA).
while attached to the radio, radio power should be turned off. If it is not, the battery begins
slowly discharging when the charger enters the trickle charge mode. This mode is
indicated by a green Ready indication, and it is entered automatically when the battery is
nearly fully charged. Gradual discharging occurs in the trickle mode because the charge
current is less than the radio standby current (of approximately 200 mA).
Be sure to read the instructions for operation of the battery charger, and follow all of them
carefully.
carefully.
Note
Be sure, especially when using nickel metal-hydride (NiMH) batteries, to put new
batteries (or batteries that have been inactive for a significant time) through at least three
batteries (or batteries that have been inactive for a significant time) through at least three
Preliminary Draft 3/9/12