E F Johnson Company 2425770 Benutzerhandbuch

Viking Portable 600 Radio Operating Manual

4-13

3 To select another list, press the Up/Down buttons. When the desired list is displayed, 

select it and exit this mode by pressing the Scan List option button again or the <F1> or 
<F2> button.

If the Scan Edit option button or menu parameter is programmed, conventional, SmartNet/
SmartZone, and P25 Trunked priority (standard) scan lists can be user programmed. 
Changes are permanent (cycling power does not reselect a default condition). Proceed as 
follows:

1 Make sure that both priority and radio wide scanning are off (

 icon not displayed). 

Select a conventional or SmartNet/SmartZone/P25 Trunked channel corresponding to 
the scan list being programmed.

2 Select the scan edit mode using the Scan Edit option button or menu parameter. This 

mode is indicated by   in the display.

3 If applicable, select the list to be edited by pressing the Up/Down buttons. Select the 

desired list by pressing the <F2> button. The selected list is indicated as “List x”. If 
user programming is disabled on a list, (conventional only) “No Edit” is momentarily 
displayed and it cannot be edited.

4 Select the channel you want to add or delete by pressing the Up/Down buttons. After 

the last channel in the current zone is displayed, the first valid channel in the next zone 
is displayed and vice versa. Lists are limited to 256. If an attempt is made to add more 
than that, “List Full” is displayed and a channel must be deleted before another can be 
added.

5 If the selected channel is in the scan list (scanned), the 

 icon is displayed. To change 

the status of the displayed channel, press the <F2> (Enter) button.

With conventional channels only, if the selected scan list is programmed with fixed 
priority channel(s), the next press of <F2> makes the current channel the priority 
channel indicated by  . If dual priority channels are used, pressing <F2> again makes 
it the second priority channel indicated by  . Then pressing <F2> again takes the 
channel out of the scan list. Refer to Sections 5.10.3 and 6.10.1 for more information on 
priority channel sampling.

6 To exit this mode and save the changes, press the <F1> (Exit) button or the Scan Edit 

option button again.