E F Johnson Company 2425M70 Benutzerhandbuch

5-13

With radio wide scanning, there is only one scan list available regardless of the type of 
channel selected. This list is user programmable and can include up to 16 channels of any 
type. For example, it could include six conventional channels and ten SMARTNET/
SmartZone channels. More information on selecting and editing radio wide scan lists 
follows.

The channels can be determined only by selecting the scan list edit mode (see “Editing 
Radio Wide Scan List” which follows).

When the displayed channel is in the scan list (scanned normally), the   symbol is 
displayed next to the zone number as shown in the following illustration.

If the RWS ED option switch is programmed, the radio wide scan list can be edited. 
Changes are permanent (cycling power does not reselect a default condition). Proceed as 
follows:

1 Make sure that both priority and radio wide scanning are OFF (the rotating   icon is 

not indicated in the right status display). Select the scan edit mode by pressing the RWS 
ED option switch. This mode is indicated by a triangle in the upper left corner of the 
display (see Figure 2.3).

2 Select the channel you want to add or delete by rotating the Select switch. A single 

beep sounds when the channel is changed (if that option is enabled). After the last 
channel in the current zone is displayed, the first valid channel in the next zone is 
displayed and vice versa. The list is limited to 16 channels. If an attempt is made to add 
more than 16, “LIST FULL” is displayed and a channel must be deleted before another 
can be added.

3 If the selected channel is in the scan list (scanned), “

” and the   symbol are displayed 

next to the zone number. To change the scan list status of the displayed channel, press 
the Select switch. A single beep sounds when the switch is pressed (if that option is 
enabled). 

4 To exit this mode and save the changes, press the RWS ED option switch again.

Scan List Indicator

Channe

Numbe