Futaba Corporation FMR-03-24G Benutzerhandbuch
121
< Model Menu (Airplane/Glider Functions) >
Reference
FMT-03 is equipped with a stick of multi-copter exclusive use. Therefore it's
unsuitable for use of an airplane, a glider and a helicopter.
S1
● S e l e c t t h e f u n c t i o n
name and return to the
preceding screen by
pushing the RTN button
or pushing the Home/Exit
button.
<Edit dial>
FLP 2
(Camber Flap)
FLP 1
(Camber Flap)
FLP 3
(Brake Flap)
FLP 4
(Brake Flap)
FLAP SETTING
[Corresponding model type]: Airplane/
glider, 2 flaps or more]
The up/down travel of each flap (camber flaps:
FLP1/2, brake flaps: FLP3/4) can be adjusted
independently at each servo according to the wing type.
● The operation reference point of each flap can be
offset
The camber flaps of a 4-flap model can be mixed
with the brake flaps. (Brake FLP to camber FLP)
● An ON/OFF switch can be set.
<Wing type: 4 flaps screen>
*The display screen is an example. The actual
screen depends on the model type.
Setting method
● Move the cursor to the flap (FLP) 1~4 up or
down item according to the wing type and
push the RTN button to switch to the data
input mode.
Adjust the travel independently.
● To offset the operation reference point
● To offset the operation reference point
of each flap, move the cursor to the
corresponding offset item. Use the edit dial
to offset the reference point.
Push the RTN button to end adjustment and
return to the cursor move mode.
●Operation reference
point offset
●Up side/Down side
adjustment
● Group/single mode switching
(For more information, refer to
the description at the back of this
manual.)
manual.)
● When using brake FLP to camber FLP mixing,
move the cursor to the [ACT/INH] item and
turn the edit dial to the left and push the RTN
button. (ON is displayed.)
When setting a switch, move the cursor to
the [--] item of the switch and push the RTN
button to call the selection screen, and then
select the switch and set its ON direction.
(Always ON at "--" setting)
(For a description of the switch selection
method, see the description at the back of
this manual.)
(CAMBER FLP setting screen)
(BRAKE FLP setting screen)
(B.FLP to C.FLP setting screen)
● Select [FLAP SETTING] at the model menu and call the
setup screen shown below by pushing the RTN button.
Scrolling
● Moving cursor
● Selecting mode
● Adjusting value
● Push the S1 button
to call next page.