Authinx Inc. MS17A Benutzerhandbuch

Remove the cover on the front of the Motion Detector and install
2 AAA alkaline batteries in the compartment. Replace the cover.

Press and hold  the TEST button on the back of the Motion
Detector for a second and then release it. This initializes the
Motion Detector and picks a random code that is used when it is
registered with the Console.

ENTER PIN
12:00 am

****
12:00 am

1. INSTALL

Entering the PIN clears the top line and shows * for each number entered. The
default PIN is 0000, you’ll find out later how you can change this, but for now press
0000 on the keyboard under the Console’s flip up lid.

This takes you to the first level of the menu at step 1. This is the INSTALLATION
level. The display looks like this:

Press OK and the display looks like this:

Press either of the Console’s 2 Menu up/down buttons (to the right of the display).
The display then shows ENTER PIN (Personal Identification Number) in the top
line.

1. INSTALL
ZONE

• Attach the Motion Detector to a wall at a height of 5 to 6 ft. using the mounting

bracket and screws provided.

• Set the slide switch (on the back) to position 1 for instant triggering for maximum

sensitivity or position 2 to trigger only after two movements have been sensed.

• Set the slide switch on the Motion Detector to position

1.

• Press and hold the TEST button for about a second.

The LED flashes twice when you release it.

• Wait 20 seconds for the Motion Detector to settle.

• Walk in front of the Motion Detector. The indicator

LED lights each time it senses movement. Check the
coverage area and reposition the sensor as required.

• Press the TEST button to return to normal operating

mode.