Authinx Inc. WR10A Benutzerhandbuch

The  WR10A comes with a CR2016 Lithium 3V battery
already installed.

1. Set the  INSTALL/RUN switch on the Console to

2. Press the face of the WR10A and hold for 2 seconds.

The Console emits a tone.

3. Set the Console's slide switch to RUN.
4. To set up additional  WR10As (up to eight), repeat

above steps.

Note: If you do not hear a tone, remove the battery and
then press down on the face of the WR10A for 2 seconds.
Refit the battery and press the face again for 2 seconds to
initialize the WR10A. You can now install the WR10A as
described above.

X-10 (USA) Inc., 91 Ruckman Rd., Closter, NJ 07624.  http://www.x10.com

WR10A-998DR

1. Set the Console’s slide switch to RUN.
2. Press the face of the WR10A and hold for 2 seconds. If

the system trips, the Console recognized the WR10A
and no further action is necessary. Press the face of the
WR10A twice quickly to stop the alarm.

1. Set the Console’s slide switch to INSTALL.
2. Press the face of the WR10A and hold for 2 seconds.

The WR10A transmits a random code to the console.
The Console acknowledges this with a beep and logs
in the WR10A.

2. Set the Console’s slide switch to RUN.

X-10 (USA) Inc. warrants X-10 products to be free from
defective material and workmanship for a period of one (1)
year from the original date of purchase at retail. X-10
(USA) Inc. agrees to repair or replace, at it’s sole discretion,
a defective X-10 product if returned to X-10 (USA) Inc.
within the warranty period and with proof of purchase.

If service is required under this warranty:

1. Return the defective unit postage prepaid to X-10

(USA) Inc. at the address below.

2. Enclose a check for $4.00 to cover postage and

handling.

3. Enclose a dated proof of purchase.
4. X-10 is not responsible for shipping damage.

F.C.C. CAUTION -  THIS DEVICE COMPLIES WITH
PART 15 OF  THE FCC RULES. OPERATION IS
SUBJECT TO THE FOLLOWING TWO  CONDITIONS:
(1)  THIS DEVICE MAY NOT CAUSE HARMFUL
INTERFERENCE, AND (2)  THIS DEVICE MUST
ACCEPT 

ANY INTERFERENCE RECEIVED ,

INCLUDING INTERFERENCE  THAT MAY CAUSE
UNDESIRED OPERATION.

NOTE: NO CHANGES OR MODIFICATIONS MAY
BE MADE TO THE UNITS.  ANY CHANGES MADE
TO THE UNITS WILL VOID THE USER'S AUTHOR-
ITY TO OPERATE THE EQUIPMENT.

1. Set the Console’s INSTALL/RUN switch to RUN.
2. Press the face of the WR10A and hold for 1 second to

trip the Panic Alarm. Press twice quickly to stop the
Alarm.

Remove the back cover and replace the battery with a
CR2016 Lithium 3V battery. After replacing the battery,
the following steps are necessary to determine that the
Console still recognizes the WR10A.