Nihon Kohden Corporation ZM-940PA Benutzerhandbuch
40
Operator's Manual ZM-940PA
Attaching the Transmitter on an Arm (Using the YP-943P/944P NIBP Cuff)
1.
Attach the NIBP cuff to the transmitter. Refer to
the “Connecting the NIBP Cuff to the
Transmitter” section.
the “Connecting the NIBP Cuff to the
Transmitter” section.
2.
Insert the end of the cuff into the belt and then
through the D ring as shown at left.
through the D ring as shown at left.
3.
Fold back the cuff at the D ring and fasten it
using the velcro tape.
using the velcro tape.
Make sure that the cuff is not attached on a joint.
NOTE
The cuff must not wrap around the elbow.
D ring
Belt
End of cuff