Nihon Kohden Corporation ZM-940PA Benutzerhandbuch
Operator's Manual ZM-940PA
43
Connecting the Electrode Lead to the Transmitter
Connect the electrode lead to the ECG/RESP socket on the transmitter.
Connect the electrode lead to the ECG/RESP socket on the transmitter.
When the transmitter is attached on an arm
CAUTION
• Do not shake or swing the transmitter while holding the leads or cables
connected to the transmitter. The transmitter may come off and injure
someone or damage surrounding instruments.
someone or damage surrounding instruments.
• Hold the connector of the electrode lead when connecting/disconnecting the
electrode lead. If you disconnect the electrode lead by pulling the lead, it
damages the electrode lead.
damages the electrode lead.
Selecting the Electrode Position
Follow the physician’s instructions for electrode placement when available.
For ECG monitoring, electrodes are attached only on the chest to allow patient movement and
obtain continuous stable ECG. Following leads are examples. When also monitoring
respiration, refer to the “Electrode Position for Respiration Monitoring” section.
Follow the physician’s instructions for electrode placement when available.
For ECG monitoring, electrodes are attached only on the chest to allow patient movement and
obtain continuous stable ECG. Following leads are examples. When also monitoring
respiration, refer to the “Electrode Position for Respiration Monitoring” section.
NOTE
The optimum electrode positions for ECG measurement of a patient are not
always optimum for respiration measurement of the patient. Select positions
suitable for both ECG and respiration measurements, or positions which have
priority for one measurement.
always optimum for respiration measurement of the patient. Select positions
suitable for both ECG and respiration measurements, or positions which have
priority for one measurement.