Glenayre Electronics Inc. GL-T8600-CN Benutzerhandbuch
DSP Exciter
Glenayre Document Number: 9110.00172
REMOVAL AND REINSTALLATION
Issue 1, Rev. I: 01/15/97
Page: 9-6
Copyright © 1997 Glenayre
Print Date: 02/19/97
7.
Position back panel on exciter chassis and secure with four sem screws. Some excit-
ers use three sem screws and one standoff in the bottom right corner.
ers use three sem screws and one standoff in the bottom right corner.
8.
Apply Vibra Tite or similar nonpermanent self-locking liquid adhesive to threads of
the two jack socket screws to be used for connector J6. Apply only to top 1/4 inch of
thread on each jack socket screw.
the two jack socket screws to be used for connector J6. Apply only to top 1/4 inch of
thread on each jack socket screw.
9.
Install two jack socket screws into connector J6 through back panel.
10.
Install two lock washers and two jam nuts over connectors J7 and J8.
11.
Install shoulder washer into regulator U58.
12.
Install three kep nuts and three screws through regulators U1, U2, and U58.
13.
Install VCO/RF amplifier board (see Table Paragraph 9.5 ).
14.
Install controller interface board (see Table Paragraph 9.4 ).
Procedure is complete. After exciter is installed in transmitter cabinet: perform setup
procedure if necessary (refer to the system and menu manuals).
procedure if necessary (refer to the system and menu manuals).