Marvelworks Limited DE300 Benutzerhandbuch
Plus Wireless Bedwetting Alarm Instructions
A. Test the transmitter and receiver:
(The transmitter and receiver have been set to the same channel when ex-factory. They are ready to use without having to pair.)
1. If there are insulation tags on the transmitter and receiver, remove them before use.
2. Test the alarm by touching the sensor tip (metal prong) with a wet finger. Press the "Reset" button to stop the alarm from
2. Test the alarm by touching the sensor tip (metal prong) with a wet finger. Press the "Reset" button to stop the alarm from
sounding.
3. If the alarm doesn't sound, please check the channel of the transmitter and receiver to see if they are the same (Please see
section E. Channel selection).
B. To adjust volume level, select operation mode and sound:
1. Open the battery compartment door and press "+" or "-" key for volume adjustment (4 levels).
2. Slide the switch inside the battery compartment for change of operation mode from "sound only" to "sound and vibration"
2. Slide the switch inside the battery compartment for change of operation mode from "sound only" to "sound and vibration"
and "vibration only".
3. To select a desired sound, choose a sound group (A or B) by sliding the sound group selection switch and then choose a sound
(1, 2 or 3) from the sound selection switch (6 sounds available for selection: A1, A2, A3, B1, B2 & B3).
4. To play the sounds at random, slide the sound group selection switch to R.
C. To attach the transmitter and the sensor:
1. Attach the transmitter to the underpants by following the steps set out below:
- Lift up the lever
- Place the waist of the underpants into the mouth of the clip
- Lock the clip by pressing down the lever
2. Attach the sensor to the outside of close-fitting underpants in the following manner:
- Lift up the lever
- Place the waist of the underpants into the mouth of the clip
- Lock the clip by pressing down the lever
2. Attach the sensor to the outside of close-fitting underpants in the following manner:
( Tip: Pull down the underpants slightly for easy fixing of sensor )
Important: The sensor should be attached with the cover facing up (as shown below)
( Note: To detach the sensor from the underpants, simply lift up the tail of the cover )
D. To stop the receiver from sounding when bedwetting occurs:
1. Press the "Reset" button on the receiver.
2. Remove the wet material from the sensor. If the sensor keeps attaching the wet underpants, the receiver will alarm again after
2. Remove the wet material from the sensor. If the sensor keeps attaching the wet underpants, the receiver will alarm again after
2 minutes.