Marvelmind Robotics 915MHZM Benutzerhandbuch
9
4.0.6
While modem is connected to the Dashboard, press DEFAULT button in the Dashboard to
upload the default settings. See the print screen below:
upload the default settings. See the print screen below:
4.0.7
Press RESET button on your modem after programming
4.0.8
After programming devices with the latest software, modem and beacons are ready for use.
4.0.9
Connect the modem/router via USB to the Windows PC with the Dashboard installed.
4.0.10
Run the Dashboard
4.0.11
In the left corner of the Dashboard Modem shall appear connected
4.0.12
Wake up all beacons by clicking on the buttons in the Dashboard on the below panel
4.0.13
If modem is not active and is not powered, the beacons will go asleep automatically after 1
minute.
minute.
The system may run for the frequency search, if it is you’re the very first waking up the
beacons. If doesn’t succeed with this step, disconnect the modem and connect that beacon
again via USB. Press the DEFAULT button in the Dashboard and Read all button to make
sure that the radio settings are really the default ones. You may compare the radio settings on
the modem and the radio settings on the beacon. They must be the same
again via USB. Press the DEFAULT button in the Dashboard and Read all button to make
sure that the radio settings are really the default ones. You may compare the radio settings on
the modem and the radio settings on the beacon. They must be the same