Unit Connection Technology Co. Ltd WS016T Benutzerhandbuch
FT016T Outdoor Thermo-Hygrometer
User Manual
1. Introduction
Thank you for your purchase of the FT016T wireless outdoor Thermo-Hygrometer. The following
user guide provides step by step instructions for installation, operation and troubleshooting.
2. Getting Started
The FT016T wireless indoor / outdoor thermo-hygrometer consists of a display console (receiver), and
a wireless thermo-hygrometer (remote transmitter).
2.1 Parts List
QTY
Item
1
Thermo-Hygrometer transmitter
Dimensions (LxWxH):6.8 x5.0 x 2.0cm
1
User Manual
2.2 Remote Thermo-Hygrometer Sensor Set Up
Note: To avoid permanent damage, please take note of the battery polarity before inserting the
batteries.
Pull down on the battery door to open the battery compartment, as shown in Figure 1.2. Insert two
fresh AAA batteries (with the negative terminal of the battery in contact with each spring). Lithium
batteries are recommended for cold weather environments. Slide the top lip of the battery door into the
battery compartment guide and snap the bottom battery door bracket into place. The LED shown in
Figure 1.1 will light up (visible through the plastic).
Figure 1
Figure 6
1. BEFORE inserting the batteries, locate the dip switches on the inside cover of the lid of
thetransmitter.
7 displays all four switches in the OFF position (factory default setting).
Figure 7
2. Channel Number: The FT016T supports up to eight transmitters. To set each channel
number (the default is Channel 1), change Dip Switches 1, 2 and 3, as referenced in Table 1.