Dynacraft BSC Inc. 8801-37U Benutzerhandbuch
Replacing wheel bearings:
When you find a wheel doesn’t rotate smoothly, is loose or makes clicking noises (and the
wheel shows few signs of wear and tear), the wheel bearing may need to be replaced
according to the following guidelines:
wheel shows few signs of wear and tear), the wheel bearing may need to be replaced
according to the following guidelines:
1. Use a 13mm socket wrench to remove
the axle locknut in the direction of arrow
A as shown.
the axle locknut in the direction of arrow
A as shown.
13mm socket
2. Remove the bearings as shown.
axle
bearing
bearing
cushion
wheel
3. After replacing bearings, replace all parts
following the diagram at right. Fasten nut D in
the direction of arrow B according to the picture
above, then rotate the wheel with your hand to
test if it is loose or does not rotate freely. If there
is nothing wrong, ride at a low speed to ensure
safety before use.
following the diagram at right. Fasten nut D in
the direction of arrow B according to the picture
above, then rotate the wheel with your hand to
test if it is loose or does not rotate freely. If there
is nothing wrong, ride at a low speed to ensure
safety before use.
WARNING:
Electric Skateboard must be powered off before replacing any
parts. Make sure your replacement part is correct and the nut
is tightened. Failure to do so could result in a loss of control
and injury!
parts. Make sure your replacement part is correct and the nut
is tightened. Failure to do so could result in a loss of control
and injury!
16
axle nut
washer