Beijing AIQI Technology Co. LTD. AIQIEDU Benutzerhandbuch
Troubleshooting
ONEBOT EDUCATIONAL ROBOT KIT User Manual
Read this manual carefully before use, and retain it for future reference
Specifications
Name: ONEBOT Educational Robot Kit
Model: AIQIEDU#01
Ages: 10+
Input voltage: 9V
Input current: 1.0A
Model: AIQIEDU#01
Ages: 10+
Input voltage: 9V
Input current: 1.0A
Manufactured by: Beijing AIQI Technology Co., LTD.
Address: Room.D1203,The 11th floor,Block D,No.9 Shangdi 3rd St., Haidian District,
Beijing,100085,China.
Thanks for choosing ONEBOT Educational Robot Kit
Press the intelligent brick’s reset button to restore factory settings should the above solutions prove ineffective.
Problem
Possible Cause
Solution
Is the controller switch turned on?
Turn on the controller switch.
Is the battery out of the power?
Replace with new batteries.
Are there batteries installed?
Install batteries.
Is the controller switch turned on?
Turn on the controller switch.
Is the battery out of the power?
Replace with new batteries.
Is your phone's Bluetooth off?
Turn on your phone’s Bluetooth.
Is there a good connection between
the device and intelligent brick?
Reconnect the intelligent
brick and device.
Has the Bluetooth
been disconnected?
Connect again via Bluetooth.
Is there a good connection between
the device and intelligent brick?
Reconnect the intelligent
brick and device.
Has the Bluetooth
been disconnected?
Connect again via Bluetooth.
Has the Bluetooth
been disconnected?
Connect again via Bluetooth.
Have you tapped the
Start button in the app?
Tap the Start button.
Is the battery out of the power?
Replace with new batteries.
Are the sensor and control
board connected
Reconnect the sensor to the
control board
The firmware update has failed.
The intelligent brick
light remains off.
Bluetooth connection failed.
The device cannot
be discovered.
The handle doesn’t
control the device.
The program does not execute.
Important Safeguards
Do not dismantle the intelligent brick, device, or battery cartridge. Remove the battery from the
battery cartridge if the product will not be used for a longtime.
Do not expose the product to heat fire, or ambient temperatures above 60°C.
Do not short circuit.
Do not crush or puncture.
Children aged 10-14 should only use this product under adult supervision.
Regularly check for damage to the electric cord, plugs, casing or other parts. If there is damage,
do not use the product until it has been repaired.
battery cartridge if the product will not be used for a longtime.
Do not expose the product to heat fire, or ambient temperatures above 60°C.
Do not short circuit.
Do not crush or puncture.
Children aged 10-14 should only use this product under adult supervision.
Regularly check for damage to the electric cord, plugs, casing or other parts. If there is damage,
do not use the product until it has been repaired.
Wireless connectivity: Bluetooth 4.2
Main materials: ABS、PC
Dimensions: 600×300×65mm
Gross weight: 1850g
Main materials: ABS、PC
Dimensions: 600×300×65mm
Gross weight: 1850g
WEEE Disposal and Recycling Information Correct Disposal of this product. This marking
indicates that this product should not be disposal with other household wastes throughout
the EU.
To prevent possible harm to the environment or human health from uncontrolled waste
disposal, recycle it responsible to promote the sustainable reuse of materials resources.
To return your used device, please use the return and collection systems or contact the
retailer where the product was purchased. They can take this product for environmental
safe recycling.
indicates that this product should not be disposal with other household wastes throughout
the EU.
To prevent possible harm to the environment or human health from uncontrolled waste
disposal, recycle it responsible to promote the sustainable reuse of materials resources.
To return your used device, please use the return and collection systems or contact the
retailer where the product was purchased. They can take this product for environmental
safe recycling.
Hereby,[Beijing AIQI Technology Co., Ltd. ] declares that the radio equipment type[designation of type of radio
equipment] is in compliance withDirective 2014/53/EU.
Declaration of Conformity
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
Attention that changes or modification not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Note: This product has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This product generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this product does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
—Consult the dealer or an experienced radio/TV technician for help.
conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
Attention that changes or modification not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Note: This product has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This product generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this product does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
—Consult the dealer or an experienced radio/TV technician for help.
This equipment should be installed and operated with a minimum distance 20cm between the
radiator and your body.
radiator and your body.
FCC ID: 2ALJ6-AIQIEDU
CHOKING HAZARD - Small parts.
Not for children under 3 years.