DaFaith Trading LLC BRISAII Benutzerhandbuch
on the basement or near a high-rise, that deteriorates the
reachability of radio waves. Please move to someplace with better
signal reachability.
3. Echo or noise: The network trunk line of certain carriers may be
in poor quality. Please tap the hang-up icon and redial, so that you
may switch to another trunk line with better quality.
4. Unable to charge the battery: Your battery may fail. Please
contact the dealer.
5.SIM card error: The metal surface of the SIM card is dirty. Rub the
metal contact terminals with a clean dry cloth.
The SIM card is not installed properly. Install it again as specified in
the user manual.
The SIM card breaks down. Contact the network service provider.
6. Unable to enter anything into Phone Book: This is possible
because that your phone book memory is full. Please delete
needless data from Contacts.
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is
subject to the condition that this device
does not cause harmful interference.
Any Changes or modifications not expressly approved by the party
responsible for compliance could void
the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the
limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against
harmful interference in a residential installation. This equipment
generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception,
which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the
interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from
that to which the receiver is
connected.
-Consult the dealer or an experienced radio/TV technician for
-Consult the dealer or an experienced radio/TV technician for
help.
Specific Absorption Rate (SAR) information:
This Smart phone meets the government's requirements for
exposure to radio waves. The
guidelines are based on standards that were developed by
independent scientific organizations through
periodic and thorough evaluation of scientific studies. The standards
include a substantial safety margin
designed to assure the safety of all persons regardless of age or
health.
FCC RF Exposure Information and Statement
The SAR limit of USA (FCC) is 1.6 W/kg averaged over one gram of
tissue. Device types: Smart phone (FCC ID: 2ALWUBRISAII) has
also been tested against this SAR limit. The highest SAR value
reported under this standard during product certification for use at
the ear is 0.533W/kg and when properly worn on the body is
1.174W/kg. the Hotspot SAR value is 1.174W/kg,the simultaneous
transmission SAR value is 0.894W/kg on the head and 1.458W/ kg
on the body. This device was tested for typical body-worn operations
with the back of the handset kept 10mm from the body. To maintain
compliance with FCC RF exposure requirements, use accessories
that maintain a 10mm separation distance between the user's body
and the back of the handset. The use of belt clips, holsters and
similar accessories should not contain metallic components in its
assembly. The use of accessories that do not satisfy these
requirements may not comply with FCC RF exposure requirements,
and should be avoided.
Body-worn Operation
This device was tested for typical body-worn operations. To comply
with RF exposure requirements, a minimum separation distance of
10mm must be maintained between the user’s body and the handset,
10mm must be maintained between the user’s body and the handset,
including the antenna. Third-party belt-clips, holsters, and similar
accessories used by this device should not contain any metallic
components. Body-worn accessories that do not meet these
requirements may not comply with RF exposure requirements and
should be avoided. Use only the supplied or an approved
antenna.