Wifi-soft Services UM310N Benutzerhandbuch
27
Tr oubl e S hoot ing:
F 1 The Failure phenomenon and solution
Failure phenomenon
Solution
SYS Indicator off
Pls make sure the PoE module connection is right. POE Port connect
with AP, LAN port connect with computer
with AP, LAN port connect with computer
Can’t land to Wireless AP through Web
page
page
Pls check the IP address of computer and Wireless AP to see whether
they are in same networking segment, The method is click
“start”-“Run” input“cmd”，ping 192.168.0.254 to test the Wireless AP
connectivity.
Reset Wireless AP and load it again;
Pls make sure the IP address 192.168.0.254 is not occupied by other
device in Wireless AP’s networking;
Check computer and cable problem, recommend to use 10/100M UTP
unshielded cable;
Clean up Arp binding from “Start”-“Run” input“cmd” arp –d
Clean the IE Brower’s temporary files and Cache file。
they are in same networking segment, The method is click
“start”-“Run” input“cmd”，ping 192.168.0.254 to test the Wireless AP
connectivity.
Reset Wireless AP and load it again;
Pls make sure the IP address 192.168.0.254 is not occupied by other
device in Wireless AP’s networking;
Check computer and cable problem, recommend to use 10/100M UTP
unshielded cable;
Clean up Arp binding from “Start”-“Run” input“cmd” arp –d
Clean the IE Brower’s temporary files and Cache file。
Wireless AP can’t connect with AP
（
（
the status display unconnected）
Try to scan the avaliable wireless networking again；
Make sure the Wireless AP’s wireless standard is correct；
The Security and passwords are matched between Wireless AP and
AP；
The signal strength of AP is too weak to connect, should be more than
-75dBm；
Make sure the Wireless AP’s wireless standard is correct；
The Security and passwords are matched between Wireless AP and
AP；
The signal strength of AP is too weak to connect, should be more than
-75dBm；
The connection of Wireless AP and AP is
success, but the computer can’t share
internet
success, but the computer can’t share
internet
Pls Check the computer’s IP address and DNS setting. If it is dynamin,
set the network card as automatically obtain. If it is static IP, pls contact
with ISP for correct IP address and DNS address.
set the network card as automatically obtain. If it is static IP, pls contact
with ISP for correct IP address and DNS address.
How to Reset Wireless AP
Press the “Reset” button more than 15 seconds after power on. The
Wireless AP will restore factory default after the Wireless AP restart.
Wireless AP will restore factory default after the Wireless AP restart.
RF Exposure: A distance of 20 cm shall be maintained between the antenna and users, and
the transmitter may not be co-located with any other transmitter or antenna.
the transmitter may not be co-located with any other transmitter or antenna.