MODERN ELECTRONICS FACTORY LIMITED 393MET8025 Benutzerhandbuch

E2

To reduce the risk of fire, do not place any heating or cooking appliance beneath this unit. 
Stop operation immediately if any liquid or solid object should fall into the cabinet. 
If the unit is not to be used for a long period of time, make sure that all power sources are 

disconnected from the unit. Unplug the AC-DC adaptor from the wall outlet. Make it a 
practice to remove the AC-DC adaptor by grasping the plug and not by pulling the cord. 

ON PLACEMENT 

Do not use the unit in places, which are extremely hot, cold, dusty or humid. 
Install the JAS-725 as far as possible from a source of noise. (for example, refrigerator, 

microwave oven, fluorescent lamp, etc.) 

Do not restrict the airflow of the unit by placing it in a place with poor ventilation, by 

covering it with a cloth or by placing it on a carpet. 

Should any trouble occur, remove the power source and refer servicing to qualified personnel. 

FCC ID : 2ANH7-393MET8025 

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two 
conditions: 

(1)

this device may not cause harmful interference, and

(2)

this device must accept any interference received, including interference that may
cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class B 
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide 
reasonable protection against harmful interference in a residential installation. This equipment 
generates, uses and can radiate radio frequency energy and, if not installed and used in 
accordance with the instructions, may cause harmful interference to radio communications. 
However, there is no guarantee that interference will not occur in a particular installation. If 
this equipment does cause harmful interference to radio or television reception, which can be 
determined by turning the equipment off and on, the user is encouraged to try to correct the 
interference by one or more of the following measures: 
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

- Consult the dealer or an experienced radio/TV technician for help.

responsible for compliance could void the user’s authority to operate the 
equipment. 

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled 

environment. This equipment should be installed and operated with minimum distance 20cm 

between the radiator & your body