MODERN ELECTRONICS FACTORY LIMITED SP717 Benutzerhandbuch
Important Safety Instructions
Please read this manual carefully before use.
Avoid the use of this speaker in the high-temperature and high humidity
environment.
environment.
Do not throw to avoid falling damage of the speaker.
Avoid self disassemble of speaker, or it will result in the failure of warranty.
Please charge speaker with power adaptor output rated voltage 5V.
Long time high volume playing is likely to cause hearing damage.
Danger of explosion if battery is incorrectly replaced. Replace only with the same
or equivalent type.
or equivalent type.
Lithium batteries, like all rechargeable batteries, are recyclable and should be
recycled or disposed of in normal household waste. Contact your local
government for disposal or recycling practices in your area. They should never be
incinerated since they might explode.
recycled or disposed of in normal household waste. Contact your local
government for disposal or recycling practices in your area. They should never be
incinerated since they might explode.
Compliance with FCC Regulation 1
FCC ID: 2ANH7-SP717
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
Note：This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
Warnings
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
1
The device has been evaluated to meet general RF exposure requirement.
The device can be used in portable exposure condition without restriction.
The device can be used in portable exposure condition without restriction.