MODERN ELECTRONICS FACTORY LIMITED 6961401USB Benutzerhandbuch
4
If the unit is not to be used for a long period of time, make sure that all power sources are
disconnected from the unit. Remove all batteries from the battery compartment.
disconnected from the unit. Remove all batteries from the battery compartment.
This unit employs a laser. The use of controls or adjustment or performance of procedures
other than those specified here may result in exposure to hazardous radiation.
other than those specified here may result in exposure to hazardous radiation.
Caution:
- Any use of the controls or performing any of the procedures in a way other than those specified herein
may result in hazardous radiation exposure.
- This unit should not be adjusted or repaired by anyone except qualified service personnel.
ON PLACEMENT
ON PLACEMENT
Do not use the unit in places which are extremely hot
,
cold, dusty or humid.
Place the unit on a flat and even surface.
Do not restrict the air-flow of the unit by placing it in a place with poor ventilation, by covering it
with a cloth or by placing it on a carpet.
with a cloth or by placing it on a carpet.
ON CONDENSATION
When left in a heated room where it is warm and damp, water droplets or condensation may form
inside the unit.
When there is condensation inside the unit, the unit may not function normally. Let it stand for 1 to
2 hours before turning the power on, or gradually heat the room up and dry the unit before use.
inside the unit.
When there is condensation inside the unit, the unit may not function normally. Let it stand for 1 to
2 hours before turning the power on, or gradually heat the room up and dry the unit before use.
Should any trouble occur, disconnect the AC Adapter and refer servicing to qualified
personnel.
personnel.
PROTECT YOUR FURNITURE
This system is equipped with non-skid rubber ‘feet’ to prevent the product from moving
when you operate the controls. These ‘feet’ are made from non-migrating rubber material
specially formulated to avoid leaving any marks or stains on your furniture. However certain
types of oil based furniture polishes, wood preservatives, or cleaning sprays may cause the
rubber ‘feet’ to soften, and leave marks or a rubber residue on the furniture.
when you operate the controls. These ‘feet’ are made from non-migrating rubber material
specially formulated to avoid leaving any marks or stains on your furniture. However certain
types of oil based furniture polishes, wood preservatives, or cleaning sprays may cause the
rubber ‘feet’ to soften, and leave marks or a rubber residue on the furniture.
To prevent any damage to your furniture we strongly recommend that you purchase small
self-adhesive felt pads, available at hardware stores and home improvement centers
everywhere and apply these pads to the bottom of the rubber ‘feet’ before you place the
product on fine wooden furniture.
self-adhesive felt pads, available at hardware stores and home improvement centers
everywhere and apply these pads to the bottom of the rubber ‘feet’ before you place the
product on fine wooden furniture.