RC4WD CTX01 Benutzerhandbuch

Phillips Screw (M3 x 10) 

Power

ON / OFF

ATV

Bind

Steering Trim Dial

LED indicator

Throttle Trim Dial

Throttle

Reverse Switch

Battery Compartment Tray

Throttle Trigger

Grip Handle

Steering Wheel

2.4 ANT

Steering

Reverse Switch

The following is an overview of the various functions and adjustments found on XR2 Ultimate Micro radio system for RC4WD models. 

It is important to read and understand about all of these functions and adjustments before driving.

* User should practice the throttle and steering approach for 

different cornering at different speeds or road surfaces.

Steering Wheel

ST. Trim Dial

TH. Trim Dial

ST Reverse Switch

TH Reverse Switch

Battery Compartment Tray

ATV

Bind

Controls direction (Left / Right)

Throttle Trigger

Controls speed (Forward / Brake / Backward)

2.4 Antenna

Transmits signal to the model

Power ON / OFF the transmitter

 Binding indicator and Low Battery indicator

Adjusts the maximum steering angle when

model turns Left / Right

Adjusts the model to run straight when

steering wheel is at center position

Contains batteries for powering the transmitter

Power ON / OFF

LED indicator

Adjusts the model to stop when throttle trigger

is at stop position

Reverse direction when operating steering wheel

Reverse direction when operating throttle trigger

Allows TX to pair with RX

(1) Use a Phillips screwdriver to remove the screw at the 

handle and remove the battery compartment cover.

(2) Install the 4x 1.5V AA batteries with correct polarity as 

marked on the battery compartment.

(3) Reinstall the battery compartment cover.

Warning: Never disassemble batteries or place the 

batteries in a fire or chemical bath.

Battery Disposal: Observe your local regulations for proper 

disposal of batteries. 

Type

Binding

Lipo

NiMH

Normal Operation

Micro RX/ESC

  

LED Flashing Quickly

LED Flashing Slowly

LED Solid On

Repeating blink two times quickly

When no signal is received at RX/ESC

Connect to Motor

Connect to Battery

 Connect to Servo

 Power ON / OFF

Setup Key

Signal LED

* The LED will remain solid during operation when the battery type is 

LiPo and RF signal is received. If user wants to select NiMH battery, 

hold the key for 5+ seconds, the RX/ESC will change to the other 

battery type. For NiMH, the LED will continually flash once RF signal is 

received.

I