Parts Express International INC PMA8 Benutzerhandbuch

See talentaudio.com for details

© Talent Sound & Lighting

TM

Last Revised:  11/22/2017

10. AUXILIARY/RECORD SECTION: The RCA jacks marked “IN” are input jacks for line level devices such as CD 

players. The 3.5 mm stereo jack marked “IN, R/L” is intended for portable media devices like cell phones, tablets, 

and laptop computers. The knob marked “LEVEL” controls the level of the AUX and RETURN input signals. The RCA 

jacks marked “OUT” can be used to send your pre-master (no effects, no master EQ, no AUX input) stereo mix to an 

outboard device such as a recorder. 

11.  EFFECTS LEVEL: This knob controls the overall level of effects sent to the channels. To increase the level, turn the 

knob to the right. To decrease the level, turn the knob to the left. 

12. ECHO LEVEL: This knob controls the reverberation level of the ECHO effect. To increase the level, turn the knob to 

the right. To decrease the level, turn the knob to the left.

13. DELAY LEVEL: This knob controls the delay time of the DELAY effect. To increase the time, turn the knob to the right. 

To decrease the time, turn the knob to the left.

14. MP3 LEVEL: This knob controls the level of the SD/USB MP3 and Bluetooth player. To increase the level, turn the 

knob to the right. To decrease the level, turn the knob to the left.

15. MASTER OUTPUT LEVEL: This knob controls the overall level of output to your speakers. To increase the level, turn 

the knob to the right. To decrease the level, turn the knob to the left. 

IMPORTANT: Turn this knob all the way to the left before powering up or connecting anything to the mixer. After all con-

nections are made, turn the mixer on and turn this knob to about one third volume (10 o’ clock position). Gradually turn it 

to the right to increase the volume of the overall output only after all channels have been adjusted to appropriate levels.

16. POWER SWITCH: This switch is used to turn the unit on or off. 

17. IEC POWER CABLE RECEPTACLE: Connect the included AC power cable here. Do NOT attempt to defeat the 

ground pin. Disconnect the cable when replacing the fuse, just below the cable receptacle.

18. SPEAKER OUTPUTS: Connect your PA speakers to these jacks with standard twist-lock (speakON- or HPC-type) 

connectors. Do not use speakers with impedance lower than 8 ohms each. 

19. RETURN: This 1/4" jack can be used for adding other line level sources. Its impedance is 10k ohms at -10 dB. 

20. SEND: This 1/4" jack will send a line level signal which mirrors the main outputs to an outboard recording device or