RM Acquisition LLC 01001A Benutzerhandbuch

 

1.  It is host specific as the FCC defines this.  See FCC document kdb 996369. 
2.  The grant limits it use to devices that are more than 20 cm from the human body.  This by 

definition is means used in fixed location and mobile devices.  See FCC rule Part 2.1091. 

3.  The module is currently authorized for the specific style antenna used in the TND-760 and the 

following information (excerpted from kdb 996369) should be understood in subsequent 
designs. 

 

Question 11: Can a module be certified where the host device must use a micro-strip trace on the 
host’s printed circuit board  to an antenna connector or a trace antenna on the host circuit board?  

 

Answer 11: A modular transmitter may be certified when the connection to the antenna is made 
through a host’s printed board micro-strip trace layout to an external connector, trace antenna or 
component (chip) antenna on a printed circuit board (herein referenced as “ trace design”). This can be 
extended to include passive parts for antenna attenuation padding, impedance matching or providing 
test ports. Other components such as amplifiers and active drivers are not considered a trace layout and 
must be contained on the module.  

 

The Form 731 application shall include detailed engineering reference designs for the trace design in 
addition to the required OEM instructions (see Comprehensive integration instructions above) for all 
trace designs approved with the module. In particular the integration instructions shall include the 
following:  

 

1. Trace layout and dimensions including specific designs for each type:  

 

a. Layout of trace design, parts, antenna ,connectors and isolation requirements;  

 

b. Boundary limits of size , thickness, length, width, shape(s) dielectric constant, and impedance must 
be clearly described for each type antenna;  

 

c. Different antenna length and shapes affect radiated emissions and each design shall be considered a 
different type; e.g., antenna length in multiple(s) of frequency wavelength and antenna shape (traces in 
phase) can affect antenna gain and must be considered;  

 

d. The above data is to be provided by a Gerber file (or equivalent) for PC layout.  

 

2. Appropriate parts by manufacturer and specifications.  

 

3. Test procedures for design verification.  

 

4. Production test procedures for ensuring compliance.  

 

Only trace designs approved at the time of grant or through permissive change can be used by the 
OEM. PCB circuit designs have an increased potential for design mishandling and they are susceptible 
to cross-talk and increased unintentional radiation. The applicant must provide compliance test data for 
all antenna circuit trace designs being marketed or used.