DDM Brands LLC GO80 Benutzerhandbuch

To add another connection, repeat all the steps. 
 

 
Once the connection is added, you need to configure the 
Internet browser: 
 
1. In Menu mode, select Services → Internet service → 
Settings → Data account, select the SIM card (if necessary) 
and choose the connection created in the previous step. 
 

 
If you use multiple SIM cards and want to switch to another 
one, follow these steps: 
 
1. Configure the connection for both SIM cards (refer to “Add 
a new connection”). 
 
2. In Menu mode, select Services → Internet service → 
Settings  → Select profile and choose SIM1 or SIM2 
according your necessities.  
 
Is possible to select Always ask, then the browser will ask 
which SIM you want to use before start the Internet session.

 

 

 

 This device complies with part 15 of the FCC Rules.Operation

 is subject to the following two conditions:(1) This device may 

not cause harmful interference,and (2)this device must accept 

any

 

interference received,including interference that may cause 

undesired operation.

Changes or modifications not expressly approved by the party

reponsible for compliance could void the user's authority to 

operate the equipment.

 Note: This equipment has been tested and found to comply with 

 

 

 

 

 

 

 

 

 

 

 

 

 

the limits for a Class B digital device, pursuant 

 These limits are designed to provide reasonable protection against harmful 

to  part 15 of the FCC Rules.

interference in  a residential installation. This equipment generates, uses and 

can radiate radio frequency energy and, if not installed  and used in accordance 

with the instructions, may cause harmful interference to radio communications. 

However,  there is no guarantee that interference will not occur in a particular 

installation. If this equipment does cause harmful  interference to radio or television

 reception, which can be determined by turning the equipment off and on, the user is  

encouraged to try to correct the interference by one or more of the following measures:   

—Reorient or relocate the receiving antenna.  

—Increase the separation between the equipment and receiver.  

—Connect the equipment into an outlet on a circuit different from that to which 

the receiver is connected.   

—Consult the dealer or an experienced radio/TV technician for help. 

are conducted using standard operating positions accepted by the FCC with the 

SAR tests 

Phone transmitting at its highest certified power level in all tested frequency bands, although

the SAR is determined at the highest certified power level, the actual SAR level of the phone

While operating can be well below the maximum value, in general, the closer you are to a 

Wireless base station antenna, the lower the power output. 

Before a new model phone is a available for sale to the public, it must be tested and certified to 

the FCC that it does not exceed the exposure limit established by the FCC, Tests for each 

phone are performed in positions and locations (e.g. at the ear and worn on the body)as 

required by the FCC. 

For body worn operation, this model phone has been tested and meets the FCC RF exposure 

accessory that Contains no metal and that positions the handset a minimum of 1.5 cm from the body. 

Non-compliance with the above restrictions may result in violation of RF exposure guidelines.