DIAS Automotive Electronic Systems Co. Ltd. TS211 Benutzerhandbuch
14
④
Then press “SET” to make sure that the two tyres will
interchange
as shown in figure 13;
⑤ Finally press “SET” again, the tyre interchange is done. Then
the display interface returns to starting status as shown in figure
10.
Fig 10 Fig 11
Fig 12 Fig 13
Warm Reminders:
① As for tyre interchange, please operate without fail according to
above steps. Otherwise the false operation may happen. This
can lead to wrong sensor installation position. Accordingly lead
to the data inaccurateness or malfunction alarm.
② After the tyre interchange, please go to specified 4S shop or
vehicle repair garage to make the inspection using special tool
to make sure that there is no mistake in changing.