DYNACO USA Inc. 6803 Benutzerhandbuch
WDD - Wireless DYNACO Dectector
USER GUIDE
Operating description
The WDD is a wireless sensing edge system. The sensing edge is conformed of, a conductive rubber section, sealed
wireless transmitter, and end cap. The sensing edge is installed the full width of the door in the doors soft bottom bag.
wireless transmitter, and end cap. The sensing edge is installed the full width of the door in the doors soft bottom bag.
Obstacles/obstructions in the door opening will be sensed by the edge when the door comes down and makes contact
with it. The conductive rubber triggers the transmitter to send a signal to the controller to reopen the door. A very short
and rapid transmission happens only when the sensing edge makes contact with an obstacle/obstruction and will not
trigger again until that sensing edge returns back to the open state.
with it. The conductive rubber triggers the transmitter to send a signal to the controller to reopen the door. A very short
and rapid transmission happens only when the sensing edge makes contact with an obstacle/obstruction and will not
trigger again until that sensing edge returns back to the open state.
The system operates according to the open loop principle. The open loop operation offers a longer life for the
transmitters lithium battery, because energy is consumed only when the sensing edge makes contact with a obstacle/
obstruction, otherwise it is inactive.
transmitters lithium battery, because energy is consumed only when the sensing edge makes contact with a obstacle/
obstruction, otherwise it is inactive.
Reference Number: WDD-US0326-12
Technical description for A
RF6803 Transmitter
Power supply:
Lithium Battery 3.6V 1.2Ah
Frequency:
868.3 MHz
Effective radiated power:
-20dBm or 10µW
Transmission Mode:
Amplitude modulation 100% or ASK
Battery Life:
10 years no transmissions or
100,000 detections minimum
100,000 detections minimum
Seal coating:
UV-cured resin
Performance:
Transmission speed 2400bps NRZ
100m operating radius in open space
100m operating radius in open space
Technical description for A
RF6838 Receiver
Power supply:
24vac or vdc
Frequency:
868.3 MHz sensitivity 0.7µV for
12dB S/N (BER0.1)
12dB S/N (BER0.1)
Bandwidth:
< 400kHz
Reception Mode:
Amplitude demodulation. Super heterodyne
with simple frequency change
with simple frequency change
Relay out::
NO - NC
Response time of the complete system:
< 500ms
Operating temperature:
-20°C to + 70°C
* DYNACO reserves the right to modify the characteristics of its products and parts without preceding notice.
DYNACO
THE SAFEST
CHOICE
Page 1 of 2
Technical description of the Sensing egde
Material:
EPDM 65 degrees shore A
Operating temperature:
-20°C to + 80°C
Protection index:
IP 67 with two sealed ends
Operating Mode:
The rubber section consists of two conductive rubber sections that each envelop a copper
wire, and an outer insulating section of non conductive rubber. Pressure lower than 10N on the
bottom of the section creates a short-circuit between the internal conductive parts and transmits
a closed contact to the extremities through the copper wires.
wire, and an outer insulating section of non conductive rubber. Pressure lower than 10N on the
bottom of the section creates a short-circuit between the internal conductive parts and transmits
a closed contact to the extremities through the copper wires.