Thermor Ltd. 261RX Benutzerhandbuch
Main Specification:
1. Indoor temperature
2. Outdoor temperature
3. Recorded daily highest and lowest temperature
4. ℃/℉ switchable(Fault:℉)
5. Low battery indicator
2. Outdoor temperature
3. Recorded daily highest and lowest temperature
4. ℃/℉ switchable(Fault:℉)
5. Low battery indicator
Before You Begin:
1.0 Set up procedure
1. Insert batteries into the monitor first.
2. Place the monitor as cl ose as possible next to the remote s ensor and insert the batteries into the
remote sensor.
3. Position the monitor and remote sensor within effective transmission range, wh ich in usual
circumstances no more than 45 meters. The range is affected by the building materials and where the
monitor and remote sensor are positioned; try various locations for the best results.
NOTE: The remote sensor should be placed in a shaded area for accurate readings
2. Place the monitor as cl ose as possible next to the remote s ensor and insert the batteries into the
remote sensor.
3. Position the monitor and remote sensor within effective transmission range, wh ich in usual
circumstances no more than 45 meters. The range is affected by the building materials and where the
monitor and remote sensor are positioned; try various locations for the best results.
NOTE: The remote sensor should be placed in a shaded area for accurate readings
1.1 Getting Started
Once the remote sensor has been powered up, the monitor will attempt to search for the signal for 3
minutes.
Once the signal is received, the dash es (- -:-) on the monitor will change to the current out door
temperature. If after 3 minutes the screen does not change to show the outdoor temperature, press
“RE-SYNC” button in the monitor. The monitor will now attempt to search for the signal for another 3
minutes.
minutes.
Once the signal is received, the dash es (- -:-) on the monitor will change to the current out door
temperature. If after 3 minutes the screen does not change to show the outdoor temperature, press
“RE-SYNC” button in the monitor. The monitor will now attempt to search for the signal for another 3
minutes.
2.0 Troubleshooting
If monitor doesn’t receive the signal more than 3 minutes, your display shows dashes (- -:-). Press
“RE-SYNC” button in the monitor. The monitor will now attempt to search for the signal for another 3
minutes.
If monitor doesn’t receive the signal about 60 minutes, the monitor will attempt to search for the signal
for another 3 minutes automatically.
If monitor doesn’t receive the signal all the time, the monitor will search for the signal for 3 minutes
every hour until signal received.
The maximum transmission range is 30 meters from the remote sensor to the monitor (in open space).
However, this depends o n the surro unding environment and i nterference levels. The temperatu re
signal travels in a straight line from the remote sensor to the monitor. The signal will not curve around
an object. If no reception is possible, despite the observation of these factors, all units will have to be
reset.
“RE-SYNC” button in the monitor. The monitor will now attempt to search for the signal for another 3
minutes.
If monitor doesn’t receive the signal about 60 minutes, the monitor will attempt to search for the signal
for another 3 minutes automatically.
If monitor doesn’t receive the signal all the time, the monitor will search for the signal for 3 minutes
every hour until signal received.
The maximum transmission range is 30 meters from the remote sensor to the monitor (in open space).
However, this depends o n the surro unding environment and i nterference levels. The temperatu re
signal travels in a straight line from the remote sensor to the monitor. The signal will not curve around
an object. If no reception is possible, despite the observation of these factors, all units will have to be
reset.