Concealite Life Safety Products SS2000 Benutzerhandbuch
Instructions
Power Connections
i
TM
Phone: 605.542.4444
WARNING: to avoid fire, shock/electrocution, or injury – TURN OFF POWER at circuit breaker or fuse and test to
ensure that power is off before wiring. Remove and discard the packaging materials. Failure to follow published
installation instructions or any modifications to the product may damage the unit and will void the warranty.
ensure that power is off before wiring. Remove and discard the packaging materials. Failure to follow published
installation instructions or any modifications to the product may damage the unit and will void the warranty.
INSTALLATION | Multiple Wiring Control Wiring Diagram
Multiple Lighting Circuit Control Wiring Diagram
*Required for two or more circuits
Option (RDS)
Yellow
Blue
Line Input
Neutral
Line Black
Neutral White
Neutral White
Load Output Red
Command Module (CM) – # of poles
i.e. CM04 - 4 lighting circuit poles
ATTENTION!
Verify line voltage is compatible with electrically held coil voltage
(120 VAC or 277 VAC)
Verify line voltage is compatible with electrically held coil voltage
(120 VAC or 277 VAC)
Specified: # of 20 AMP Circuits
6
Load must not exceed 800 watts @ 120
VAC. Load must not exceed 1200 watts
@ 277 VAC. Loads in excess must use
the Command Module option for higher
wattage.
VAC. Load must not exceed 1200 watts
@ 277 VAC. Loads in excess must use
the Command Module option for higher
wattage.
§
Command Module option.
Dimming ballast circuits must be controlled by the
§
Parallel connect multiple (two or more) sensors for areas
exceeding range coverage of one lighting sensor.
exceeding range coverage of one lighting sensor.
SpaceStation
Occupancy
Sensor
Override FDP
Concealed Wall Switch
Concealed Wall Switch
Optional:
A
A – Optional B – Optional C – Load Information D – Command Module Information
C
B
D
Option (OR)
Load
Optional:
Remote Daylight Sensor
Remote Daylight Sensor
TWO OR MORE SENSORS OPERATING TOGETHER
v.092611–SS