EnGenius Technologies ECB300 Benutzerhandbuch

Seite von 113
107 
 
Appendix A – FCC Interference Statement 
 
Federal Communication Commission Interference Statement 
 
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.  These limits 
are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can 
radiate  radio  frequency  energy  and,  if  not  installed  and  used  in  accordance  with  the  instructions,  may  cause  harmful  interference  to  radio 
communications.  However, there is no guarantee that interference will not occur in a particular installation.  If this equipment does cause harmful 
interference  to  radio  or  television  reception, which  can  be  determined  by  turning  the  equipment  off  and on,  the  user  is  encouraged  to  try  to 
correct the interference by one of the following measures: 
 
 
Reorient or relocate the receiving antenna. 
 
Increase the separation between the equipment and receiver. 
 
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. 
 
Consult the dealer or an experienced radio/TV technician for help. 
 
FCC  Caution:  Any  changes  or  modifications  not  expressly  approved  by  the  party  responsible  for  compliance  could  void  the  user's  authority to 
operate this equipment. 
 
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful 
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. 
 
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. 
 
IMPORTANT NOTE: 
FCC Radiation Exposure Statement: 
This  equipment complies with  FCC radiation exposure  limits  set  forth  for an uncontrolled  environment.  This  equipment  should  be installed and 
operated with minimum distance 20cm between the radiator & your body. 
 
Note: The country code selection is for non-US model only and is not available to all US model. Per FCC regulation, all WiFi product marketed in US 
must fixed to US operation channels only.