ABRACON CORPORATION ABBTM2-4G Benutzerhandbuch
ABBTM-2.4GHz-T
Bluetooth Module
Date of Issue: January 10
th
, 2012
26.9 * 13.0 * 2.5 mm SMT
ESD Sensitive
Page (13) of (17)
Abracon Drawing # 453368
Revision #: Initial
10.4
Special
Considerations:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
a)
this device may not cause harmful interference
b)
this device must accept any interference received, including interference that may cause
undesired
operation
Changes or modifications not expressly approved by the party responsible for compliance could void the
user’s authority to operate this device.
user’s authority to operate this device.
This device has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This device generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation.
If this device does cause harmful interference to radio or television reception, which can be determined by
turning the device off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This device generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation.
If this device does cause harmful interference to radio or television reception, which can be determined by
turning the device off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
Reorient or relocate the receiving antenna
Increase the separation between this device and the receiver
Bias this device from an outlet on a circuit different from that to which the receiver is
connected
Consult the dealer or an experienced radio/TV technician for assistance
Please notice that if the FCC identification number is not visible when the module is installed inside
another device, then the outside of the device into which the module is installed must also display a label
referring to the enclosed module. This exterior label can use wording such as the following:
“Contains FCC ID:
A8RABBTM2-4G
”
any similar wording that expresses the same meaning may also be used.