Hong Fu Jin Precision Electrons Co. Ltd. MRDB20 Benutzerhandbuch
Canada-Industry Canada (IC)
This device complies with RSS-210 of Industry Canada.
Operation is subject to the following two conditions:
(1) This device may not cause interference, and
(2) This device must accept any interference, including interference that may cause undesired operation of
this device.
L ‘ utilization de ce dispositif est autorisée seulement aux conditions suivantes :
(1) il ne doit pas produire de brouillage et
(2) l’ utilisateur du dispositif doit étre prêt à accepter tout brouillage radioélectrique reçu, même si ce
brouillage est susceptible de compromettre le fomctionnement du dispositif.
Labeling
NFC Module “MIC-001” is labeled as below.
IC: 5825B-MRDB20
The label with IC No. is to be placed on the module. If IC No. is not visible when the module is installed into
the system, “Contains IC: 5825B-MRDB20” shall be placed on the outside of final host system.
The term “IC” before the equipment certification number only signifies that the Industry Canada technical
specifications were met.
Caution: Exposure to Radio Frequency Radiation
This device must not be co-located or operating in conjunction with any other antenna or transmitter.
Instructions to OEM Integrators
A User manual provided to the end user must indicate the operating requirements and conditions that must
be observed to ensure compliance with the above-mentioned IC RF Exposure guideline.
If other radio devices are to be integrated with this module, an additional evaluation and IC submission may
be required. Integrators are responsible for such additional evaluation and IC submission.
the system, “Contains IC: 5825B-MRDB20” shall be placed on the outside of final host system.
The term “IC” before the equipment certification number only signifies that the Industry Canada technical
specifications were met.
Caution: Exposure to Radio Frequency Radiation
This device must not be co-located or operating in conjunction with any other antenna or transmitter.
Instructions to OEM Integrators
A User manual provided to the end user must indicate the operating requirements and conditions that must
be observed to ensure compliance with the above-mentioned IC RF Exposure guideline.
If other radio devices are to be integrated with this module, an additional evaluation and IC submission may
be required. Integrators are responsible for such additional evaluation and IC submission.
Page 4 of 4