NEC Corporation of America BSA1946 Benutzerhandbuch

Seite von 29
12
Vo
ice/Videophone Ca
lls
● When you receive a FOMA voice or 
videophone call with a message
The Chaku-moji appears on the ringing screen. The 
Chaku-moji disappears when you answer the call.
z The received Chaku-
moji is displayed in 
3D animation.
● Displaying a message from Received calls
When you receive Chaku-moji, the “
” icon 
appears on the Received calls entry, and you can 
check the Chaku-moji on the “Received calls” screen 
(detail).
Showing/Hiding Caller ID 
When Making a Call
Adding the “186”/“184” prefix to the 
other party’s phone number
To show your caller ID, add the “186” prefix when you 
dial the phone number. To hide your caller ID, add the 
“184” prefix.
z This function cannot be used for a WLAN voice call.
To show your phone number
186 - (The other party’s phone number)
X
r (voice call) or [ch] (V.phone)
To hide your phone number
184 - (The other party’s phone number)
X
r (voice call) or [ch] (V.phone)
Showing/Hiding your caller ID from the 
function menu
Show/Hide your caller ID using the function menu of a 
detail screen such as “Enter phone number” screen, 
“Phonebook”, “Received calls”, “Dialed calls” or 
“Redial”.
<Example: To make a FOMA voice call from the Enter 
phone number screen>
1
Enter the phone number of the 
other party
2
[MENU] (FUNC)
X
“Notify Caller 
ID”
X
“OFF” or “ON”
N
z
Charges apply to send Chaku-moji. Charges do 
not apply to receive Chaku-moji.
z
You can store up to 30 Chaku-moji in Sent 
messages (Regardless of the modes in the use of 
2in1, up to 30 Sent messages are stored in A and 
B numbers, respectively). When you send the 
same Chaku-moji repeatedly, only the latest one is 
recorded. When the number of entries exceeds 
the maximum, older entries are overwritten.
z
If the receiver’s handset is under the following 
conditions, Chaku-moji cannot be sent. In this 
case, no sending charges apply.
• The handset does not support Chaku-moji 
(“Transmission failed” appears)
• Chaku-moji does not appear on the receiver 
display due to the “MSG display settings” on the 
receiver handset (“Transmission failed” appears)
• Public mode (Driving mode) is set
• The ringing time for Record message is set to 0 
second
• “
” is displayed or the power is off
z
Depending on the signal quality, the transmission 
result may not appear on the sender terminal even 
when the receiver terminal receives Chaku-moji. 
In this case, sending charges apply.
z
You cannot send or receive Chaku-moji overseas.
N
z
Even when you receive a call whose ring tone 
sounded for a shorter time than the time set in 
“Set mute seconds” under “Ring time (sec.)”, 
Chaku-moji is displayed and recorded in Received 
calls.
z
Some pictograms are not displayed in 3D 
animation.
z
Depending on the status of the sender or receiver, 
Chaku-moji may not be displayed even when you 
receive a call with Chaku-moji.
Ex: FOMA voice call
Chaku-moji
z
You can store up to 30 Chaku-moji in Sent 
messages (when 2in1 is active, up to 30 sent 
messages are stored for Number A and up to 30 
for Number B regardless of the mode).
N
z
Even when you make a call using the Received 
calls entry, the Chaku-moji in the entry is not sent.
N
REA_Tel.fm  12 ページ  2009年7月31日 金曜日 午後10時4分