NEC Corporation of America KMP6J1BJ Benutzerhandbuch

•

You MUST NOT stop on the hard shoulder of a motorway to answer or make a call, 

except in an emergency.

•

Switch off your phone at a refuelling point, such as a petrol station, even if you are not 

refuelling your own car.

•

Do not store or carry flammable or explosive materials in the same compartment where 

a radio transmitter, such as a cellphone, is placed.

•

Electronic vehicle systems, such as anti-lock brakes, speed control and fuel injection 

systems are not normally affected by radio transmissions. The manufacturer of such 

equipment can advise if it is adequately shielded from radio transmissions. If you 

suspect vehicle problems caused by radio transmissions, consult your dealer and do 

not switch on your phone until it has been checked by qualified approved installers.

An air bag inflates with great force. Do not place objects, including either installed or 

portable wireless equipment, in the area over the air bag or in the air bag deployment 

area. If in-vehicle wireless equipment is improperly installed and the air bag inflates, 

serious injury could result.

The use of third party equipment, cables or accessories, not made or authorized by NEC, 

may invalidate the warranty of your cellphone and also adversely affect the phone’s 

operation. For example use only the NEC mains cable supplied with the AC charger.

The cellphone, batteries and charger contain no user-serviceable parts. We recommend 

that your NEC cellphone is serviced or repaired by an NEC authorized service centre. 

Please contact your Service Provider or NEC for advice.

The radio equipment shall be connected to the antenna via a non-radiating cable (e.g. 

coax).

The antenna shall be mounted in a position such that no part of the human body will 

normally rest close to any part of the antenna unless there is an intervening metallic 

screen, for example, the metallic roof.

Use only an antenna that has been specifically designed for your phone. Use of 

unauthorized antennas, modifications or attachments could damage your phone and 

may violate the appropriate regulations, causing loss of performance and radio 

frequency (RF) energy above the recommended limits.

For optimum performance with minimum power consumption, note the following:

•

Your phone has the internal antenna. Do not cover part of the internal antenna of the 

phone with your hands. This affects call quality, may cause the phone to operate at a 

higher power level than needed and may shorten talk and standby times.

Your phone is a low-power radio transmitter and receiver. When it is turned on, it 

intermittently receives and transmits radio frequency (RF) energy (radio waves). The 

system that handles the call controls the power level at which the phone transmits.

Your phone is designed not to exceed the limits for exposure to RF energy set by 

national authorities and international health agencies. * These limits are part of 

comprehensive guidelines and establish permitted levels of radio wave exposure for the 

general population. The guidelines were developed by independent scientific 

organizations such as ICNIRP (International Commission on Non-Ionizing Radiation 

Protection) through periodic and thorough evaluation of scientific studies. The limits 

include a substantial safety margin designed to assure the safety of all persons, 

regardless of age and health, and to account for any variations in measurements.

*Examples of radio frequency exposure guidelines and standards that your phone is 

designed to conform to:

•

ICNIRP, “Guidelines for limiting exposure to time-varying electric, magnetic, and 

electromagnetic fields (up to 300 G Hz)-International Commission on Non-Ionizing 

Radiation Protection (ICNIRP)”.

Health Physics, vol. 74. pp, 494-522, April 1998.

•

99/519/EC Council Recommendation on the limitation of exposure to the general 

public to electromagnetic fields 0 Hz-300 GHz, Official Journal of the European 

Communities, July 12,1999.

•

ANSI/IEEE C95.1-1992. “Safety levels with respect to human exposure to radio 

frequency electromagnetic fields, 3kHz to 300 GHz”. The Institute of Electrical and 

Electronics Engineers Inc., New York, 1991.

•

FCC Report and Order, ET Docket 93-62, FCC 96-326, Federal Communications 

Commission (FCC), August 1996.

•

Radio communications (Electromagnetic Radiation Human Exposure) Standard 1999, 

Australian Communications Authority (ACA), May 1999.

•

This product complies with the requirements of the R&TTE Directive 1999/5/EC. The 

‘Declaration of Conformity’ leaflet can be found within this box.

•

EU-wide legislation as implemented in each Member State requires 

that used electrical and electronic products carrying the mark (left) 

must be disposed of separately from normal household waste. This 

includes mobile telephones or electrical accessories, such as 

chargers or headsets. When you dispose of such products, please 

follow the guidance of your local authority and/or ask the shop where 

you purchased the product. The mark on the electrical and electronic 

products only applies to the current European Union Member States. 

•

If you wish to dispose of used electrical and electronic products 

outside the European Union, please contact your local authority and 

ask for the correct method of disposal.

•

T9

®

 Text Input and the T9 logo are registered trademarks of Tegic Communication.

“T9 Text Input is licensed under one or more of the following:
U.S. Pat. Nos. 5,187,480, 5,818,437, 5,945,928, 5,953,541, 6,011,554, 6,286,064, 

6,307,548, 6,307,549, and 6,636,162, 6,646,573; Australian Pat. Nos. 727539, 

746674, and 747901; Canadian Pat. Nos. 1,331,057, 2,302,595, and 2,227,904; Japan 

Pat. No. 3532780, 3492981; United Kingdom Pat. No. 2238414B; Hong Kong 

Standard Pat. No. HK1010924; Republic of Singapore Pat. No. 51383, 66959, and 

71979; European. Pat. Nos. 0 842 463 (96927260.8), 1 010 057 (98903671.0), 1 018 

069 (98950708.2); Republic of Korea Pat. Nos. KR201211B1 and KR226206B1. 

People’s Republic of China Pat. Application Nos. 98802801.8, 98809472.X and 

96196739.0; Mexico Pat. No. 208141; Russian Federation Pat. No. 2206118; and 

additional patents are pending worldwide”