NEC Corporation of America KMP6J1CH Benutzerhandbuch

•

Electronic vehicle systems, such as anti-lock brakes, speed 

control and fuel injection systems are not normally affected by 

radio transmissions. The manufacturer of such equipment can 

advise if it is adequately shielded from radio transmissions. If 

you suspect vehicle problems caused by radio transmissions, 

consult your dealer and do not switch on your phone until it has 

been checked by qualified approved installers.

An air bag inflates with great force. Do not place objects, 

including either installed or portable wireless equipment, in the 

area over the air bag or in the air bag deployment area. If in-

vehicle wireless equipment is improperly installed and the air 

bag inflates, serious injury could result.

The use of third party equipment, cables or accessories, not 

made or authorized by NEC, may invalidate the warranty of your 

cellphone and also adversely affect the phone’s operation. For 

example use only the NEC mains cable supplied with the AC 

charger.

The cellphone, batteries and charger contain no user-

serviceable parts. We recommend that your NEC cellphone is 

serviced or repaired by an NEC authorized service centre. 

Please contact your Service Provider or NEC for advice.

The radio equipment shall be connected to the antenna via a 

non-radiating cable (e.g. coax).

The antenna shall be mounted in a position such that no part of 

the human body will normally rest close to any part of the 

antenna unless there is an intervening metallic screen, for 

example, the metallic roof.

Use only an antenna that has been specifically designed for your 

phone. Use of unauthorized antennas, modifications or 

attachments could damage your phone and may violate the 

appropriate regulations, causing loss of performance and radio 

frequency (RF) energy above the recommended limits.

For optimum performance with minimum power consumption, 

note the following:

•

Your phone has the internal antenna. Do not cover part of the 

internal antenna of the phone with your hands. This affects call 

quality, may cause the phone to operate at a higher power 

level than needed and may shorten talk and standby times.

Your phone is a low-power radio transmitter and receiver. When 

it is turned on, it intermittently receives and transmits radio 

frequency (RF) energy (radio waves). The system that handles 

the call controls the power level at which the phone transmits.

Your phone is designed not to exceed the limits for exposure to 

RF energy set by national authorities and international health 

agencies. * These limits are part of comprehensive guidelines 

and establish permitted levels of radio wave exposure for the 

general population. The guidelines were developed by 

independent scientific organizations such as ICNIRP 

(International Commission on Non-Ionizing Radiation 

Protection) through periodic and thorough evaluation of 

scientific studies. The limits include a substantial safety margin 

designed to assure the safety of all persons, regardless of age 

and health, and to account for any variations in measurements.

*Examples of radio frequency exposure guidelines and 

standards that your phone is designed to conform to:

•

ICNIRP, “Guidelines for limiting exposure to time-varying 

electric, magnetic, and electromagnetic fields (up to 300 G 

Hz)-International Commission on Non-Ionizing Radiation 

Protection (ICNIRP)”.

Health Physics, vol. 74. pp, 494-522, April 1998.

•

99/519/EC Council Recommendation on the limitation of 

exposure to the general public to electromagnetic fields 0 Hz-

300 GHz, Official Journal of the European Communities, July 

12,1999.

•

ANSI/IEEE C95.1-1992. “Safety levels with respect to human 

exposure to radio frequency electromagnetic fields, 3kHz to 

300 GHz”. The Institute of Electrical and Electronics Engineers 

Inc., New York, 1991.

•

FCC Report and Order, ET Docket 93-62, FCC 96-326, 

Federal Communications Commission (FCC), August 1996.

•

Radio communications (Electromagnetic Radiation Human 

Exposure) Standard 2003, Australian Communications Media 

Authority.

This equipment has been tested and found to comply with the 

limits for a Class B digital device, pursuant to Part 15 of the FCC 

Rules. These limits are designed to provide reasonable 

protection against harmful interference in a residential 

installation. This equipment generates, uses and can radiate 

radio frequency energy and, if not installed and used in 

accordance with the instructions, may cause harmful 

interference to radio communications. However, there is no 

guarantee that interference will not occur in a particular 

installation If this equipment does cause harmful interference to 

radio or television reception, which can be determined by turning 

the equipment off and on, the user is encouraged to try to correct 

the interference by one or more of the following measures:

•

Reorient or relocate the receiving antenna.

•

Increase the separation between the equipment and receiver.

•

Connect the equipment into an outlet on a circuit different from 

that to which the receiver is connected.

•

Consult the dealer or experienced radio/TV technician for help.

This equipment complies with part 15 of the FCC Rules. 

Operation is subject to the following two conditions: 

(1)This device may not cause harmful interference.

(2)This device must accept any interference received, including 

interference that may cause undesired operation.

Changes or modifications not expressly approved by the party 

responsible for compliance could void the user's authority to 

operate the equipment.

•

T9

®

 Text Input and the T9 logo are registered trademarks of 

Tegic Communication.

“T9 Text Input is licensed under one or more of the following:
U.S. Pat. Nos. 5,187,480, 5,818,437, 5,945,928, 5,953,541, 

6,011,554, 6,286,064, 6,307,548, 6,307,549, and 6,636,162, 

6,646,573; Australian Pat. Nos. 727539, 746674, and 747901; 

Canadian Pat. Nos. 1,331,057, 2,302,595, and 2,227,904; 

Japan Pat. No. 3532780, 3492981; United Kingdom Pat. No. 

2238414B; Hong Kong Standard Pat. No. HK1010924; 

Republic of Singapore Pat. No. 51383, 66959, and 71979; 

European. Pat. Nos. 0 842 463 (96927260.8), 1 010 057 

(98903671.0), 1 018 069 (98950708.2); Republic of Korea Pat. 

Nos. KR201211B1 and KR226206B1. People’s Republic of 

China Pat. Application Nos. 98802801.8, 98809472.X and 

96196739.0; Mexico Pat. No. 208141; Russian Federation 

Pat. No. 2206118; and additional patents are pending 

worldwide”

•

RSA™ is a registered trademark of RSA Data Security Inc.

•

OPENWAVE™ is a registered trademark of Openwave 

Systems Inc.

•

USE OF THIS PRODUCT IN ANY MANNER THAT 

COMPLIES WITH THE MPEG-4 VISUAL STANDARD IS 

PROHIBITED, EXCEPT FOR USE DIRECTLY RELATED TO 

(A) DATA OR INFORMATION ENCODED BY A CONSUMER