NEC Corporation of America NII5120 Benutzerhandbuch

2

■ To switch the setting of Hyper Clear Voice

→P.5

■ To switch a voice/videophone call during 

→P.3

■ To put the current voice/videophone call 

→P.62

■ When the 2in1 is in Dual mode
The Outgoing number selection screen appears. 
Select a phone number. 

3

y

When a videophone call is not connected, the cause 
of the failure appears. 

z The cause may not appear depending on the 

situation. 

z Depending on the type of other party’s phone or the 

possible lack of a network service subscription, the 
reason may not accurately reflect the other party’s 
actual status. 

z If the videophone call is not connected, your call is 

automatically switched to a voice call when you set 
“Auto redial as voice” to “ON”. However, the call 
may not be handled in this way if you call an ISDN 
synchronous 64K or an ISDN videophone which 
does not support the 3G-324M standard (as of 
September, 2008) or if you dial a wrong number. 
Note that call charge may be applied in some 
cases.

Check number then 
redial

The called phone number is not 
used

Busy

The line is busy
• This message may also 

appear during packet 
communication. 

Busy with packet 
transmission

The other party is using packet 
communication

Out of service area/
power off

The other party is out of service 
area or the phone is turned off

Your call is being 
forwarded

The call is being forwarded (A 
Videophone call is made when 
the forwarding number is for a 
3G-324M-compatible 
videophone)

Redial using voice 
call

The phone for the forwarding 
number is not compatible with 
videophone calls

Please activate 
caller ID before 
dialing again

The other party sets the Caller 
ID request service

This number is not 
available

The other party sets the 
Nuisance call blocking service

Upper limit has been 
exceeded 
Connection failed

The upper limit set for a Limit 
billing plan (Type Limit and 
Family Wide limit) is exceeded

Connection failed

You connected without notifying 
your caller ID (when dialing into 
visualnet, etc.)
• This message may also 

appear in other situations

Set the caller ID notification to 
“ON” and retry

Please make your 
call from the i-mode 
web page

You attempted to make a 
videophone call to watch V-live 
without browsing the i-mode 
official site