RadioShack Corporation 120358 Benutzerhandbuch

This product is not designed, manufactured, sponsored, or endorsed by Apple Computer, Inc. iPod is a trademark of Apple Computer, Inc., registered in the U.S. and other countries.

12-358

09A07

P/N: AO0295AAA1

Printed in China

Thank you for purchasing your FM transmitter

from

RadioShack. This FM Transmitter with

auto scanning function connects to your iPod

for recharge and allows listening to music

through your FM radio. Please read this user’s

guide before installing, setting up, or using

your new FM transmitter.

WHAT’S INCLUDED

FM Transmitter

User’s Guide

SPECIFICATIONS

Power ...............................................Lighter socket in vehicle
Transmitting frequency . 88.1-107.9 MHz with 0.2 MHz step

Operating range ..................................................... 10 - 30 feet
Specifications are subject to change and improvement

without notice. Actual product may vary from the images

found in this document.

RF EMISSIONS INFORMATION

This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15

of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause
harmful interference to radio communications. However,

there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more
of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and

receiver.

• Connect the equipment into an outlet on a circuit

different from that to which the receiver is connected.

Consult your local

RadioShack store or an experienced

radio/TV technician for help.
If you cannot eliminate the interference, the FCC
requires that you stop using your equipment. Changes or

modifications not expressly approved by

RadioShack may

cause interference and void the user’s authority to operate

the equipment.
This device complies with Part 15 of the FCC rules. Operation
is subject to the following two conditions: (1) This device

may not cause harmful interference, and (2) This device must
accept any interference received, including interference that
may cause undesired operation.

LIMITED 90-DAY WARRANTY

This product is warranted by

RadioShack against

manufacturing defects in material and workmanship under
normal use for ninety (90) days from the date of purchase

from authorized

RadioShack dealers. For complete warranty

details and exclusions, check with your dealer or contact

RadioShack directly.
RadioShack Customer Relations

300 RadioShack Circle, Fort Worth, TX 76102

04/04

12-358

FM Transmitter

Tuning the Transmitter

Selecting a Saved Frequency

To select a saved frequency, press 1/), 2/(
or 3/M to select the memory location.

The

corresponding LED lights and the display shows the
frequency.

Scanning for a Frequency

If necessary, you can search for a clear, unused
frequency:
To start a search, hold down 2/( and 3/M and
simultaneously, then press 1/) for about 2

seconds. This may take several seconds.

Manually Tuning a Frequency

You can manually tune your transmitter:
1. Hold down 3/M until all LEDs are flashing for

manual search.

2. Repeatedly press 1/) or 2/( to find the

desired frequency.

Saving Frequencies

To save a displayed frequency, hold down 3/M until
all LEDs are flashing, then hold down 1/), 2/( or

3/M for two seconds. The transmitter assigns the
frequency to that button.

Patent Pending

IMPORTANT SAFETY INFORMATION

Connect and operate this product BEFORE
operating your vehicle and pay attention to the road.

Attempting to drive and scan your set at the same
time can cause a serious traffic accident! Drive
responsibly.

Step 1: Connect the Transmitter

1. Plug the transmitter’s barrel plug into your car’s

’s barrel plug into your car’s

into your car’s

power outlet. The LED lights and the transmitter

outlet. The LED lights and the transmitter

displays the last used frequency.

2. Insert the iPod 30-pin connector into your iPod.

Your iPod will start charging.

Step 2: Tune Your Radio

Tune your FM radio to the frequency displayed on the
transmitter.

Step 3: Listen to Your Music

To listen to your music, use the volume controls on
radio to adjust the volume. If the sound is unclear,
you can tune your transmitter and radio to a new
frequency. See “Tuning the Transmitter.”
Note: The volume control on your iPod doesn’t
control the sound on the radio.

Connect to your iPod

Connect to the
car’s lighter socket.

For easier viewing, press 1/) and 2/(
simultaneously to dim or brighten the display.

Interference caused by car antenna location, car design, physical location and obstructions such as steel
bridges and parking garages can prevent the transmitter from detecting frequencies and limit sound quality.

In these cases, you can select a saved frequency, scan for a clear frequency, or manually tune a frequency.