Panasonic Corporation of North America 9TGCF-304 Benutzerhandbuch

5

  THIS EQUIPMENT IS SUITABLE FOR USE IN 

CLASS I,DIVISION2,GROUPS A,B,C, AND D OR 

NON-HAZARDOUS LOCATIONS ONLY.

 WARNING-EXPLOSION HAZARD-SUBSTITUTION 

OF COMPONENTS MAY IMPAIR SUITABILITY FOR 

CLASSI,DIVISION2.

  When connecting and using a device manufactured by 

a third party,enquire to the manufacturer as to whether 

the device suits CLASS1,DIVISION2.

33-Ca-1

<Only for models with wireless LAN/Bluetooth>
Industry Canada
This product complies with RSS210 Industry Canada.

Operation is subject to the following two conditions;

(1) this device may not cause interference, and

(2) this device must accept any interference, including inter-

ference that may cause undesired operation of the device.

<Only for models with wireless LAN>

This product (local network devices) for the band 5150-5250 

MHz is only indoor usage to reduce potential for harmful 

interference to co-channel Mobile Satellite systems.

High power radars are allocated as primary users (meaning they 

have priority) of 5250-5350 MHz and 5650-5850 MHz and these 

radars could cause interference and/or damage to LELAN devices.

30-Ca-1

This device has been designed to operate with an anten-

na having a maximum gain of 2.15 dBi. Antenna having a 

higher gain is strictly prohibited per regulations of Industry 

Canada. The Required antenna impedance is 50 ohms.

To reduce potential radio interference to other users, the 

antenna type and its gain should be so chosen that the 

equivalent isotropically radiated power (EIRP) is not more 

than that required for successful communication.

25-Ca-1-1

<Only for models with wireless LAN>
RF Exposure Warning
This equipment has been approved for mobile operation, 

and unless otherwise advised in separate supplemental 

instructions for individual wireless transmitter(s), requires 

minimum 20 cm spacing be proved between antenna(s) 

and all person’s body (excluding extremities of hands, 

wrist and feet) during wireless modes of operation.
<Pour modèles LAN sans fi l uniquement>
Mise en garde concernant l’exposition à l’énergie 

radiofréquence
Cet équipement a été homologué pour un fonctionnement 

sans fi l et, sauf avis contraire inclus dans la notice d’utili-

sation d’un autre émetteur sans fi l, une distance minimale 

de 20 cm doit être assurée entre l’antenne et le corps 

de toute personne (à l’exclusion des mains, poignets et 

pieds) pendant le fonctionnement sans fi l.

25-M-5-1

Declaration of Conformity (DoC)
“Hereby, we declare that this Personal Computer is in compliance with the essential requirements 

and other relevant provisions of the Directive 1999/5/EC.”

Hint:

If you want to get a copy of the original DoC of our products which relates to the R&TTE, please con-

tact our web address: http://www.doc.panasonic.de

Contact:

Panasonic Services Europe

A Division of Panasonic Marketing Europe GmbH

Panasonic Testing Centre

Network connection.

The terminal equipment is intended for connection to the following public network;

In all the countries of European Economical Area;

- Public Switched Telephony Networks

Technical Features.

The terminal equipment includes the following features;

- DTMF dialing

- Maximum bitrate receiving mode: 56 kbit/s

- Maximum bitrate sending mode: 33.6 kbit/s

This product is designed to interwork with the Public Switched Telecommunication Networks in UK, Ireland, Nether-

lands, Sweden, Denmark, Finland, Switzerland, Luxembourg, Belgium, France, Germany, Spain, Portugal, Iceland, 

Greece, Italy, Norway and Austria.

18-E-1

Compliance Notice - CE Mark
This equipment is in conformance with the requirements of the European Council Directive listed below:
73/23/EEC Low Voltage Directive with amendment 93/68/EEC
89/336/EEC EMC Directive with amendments 92/31/EEC and 93/68/EEC
1999/5/EC R&TTE

21-E-1