Arris HDUDTAP2 Benutzerhandbuch

HD-DTA100u

Quick Start Guide

© 2014 ARRIS Enterprises, Inc. All rights reserved. No part of this publication may be reproduced in any form or by any means 
or used to make any derivative work (such as translation, transformation, or adaptation) without written permission from ARRIS 
Enterprises, Inc.

ARRIS reserves the right to revise this publication and to make changes in content from time to time without obligation on the 
part of ARRIS to provide notification of such revision or change. ARRIS provides this publication without warranty of any kind, 
implied or expressed, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose. 
ARRIS may make improvements or changes in the product(s) described in this publication at any time.

594797-001-a    01/14 

The HD-DTA100u 
will not turn on

•  Make sure the POWER LED on the front of the HD-DTA100u is lit 

green.

•  If the HD-DTA100u is connected to a switched outlet, make sure the 

switch is turned on. It is recommended to use an unswitched outlet, 
if possible.

•  Unplug the HD-DTA100u from the AC outlet, and then plug it back in.
•  Make sure the remote control is in DTA mode, and turn the  

HD-DTA100u on by pressing the DTA button.

The remote control 
does not work

•  Make sure the remote control is in DTA mode.
•  Make sure there are no obstructions between the remote control 

and the HD-DTA100u. Aim the remote control directly at the  
HD-DTA100u front panel, not the TV or VCR.

•  The angle between the remote control and the HD-DTA100u may be 

too large. Stand in front of the HD-DTA100u and not too far to either 
side.

•  Press and release operation buttons one at a time, firmly and 

deliberately.

•  Check the batteries in the remote control. Install new batteries if 

needed.

There is no video 
on the TV screen

•  Make sure the TV is on and set to the appropriate input source for 

the HD-DTA100u.

•  Make sure the HD-DTA100u is on and tuned to an authorized cable 

channel.

•  Make sure the cables between the HD-DTA100u and the TV are 

firmly connected.

•  Make sure the coaxial cable feed is firmly connected to the 

HD-DTA100u and the wall jack.

There is no audio 
when viewing 
cable channels

•  Press MUTE on the remote control to restore sound.

No closed captions 
display

•  Make sure closed captions are enabled on the TV. (Note: Closed 

captioning may not be available for the current program.)

Troubleshooting

Check here before calling your service provider.