Napco Security Systems Inc VKEYFOB Benutzerhandbuch

 Remove the Phillips head screw on the

back of KeyFob.

Lift top of case from bottom.

 Remove old battery and insert new battery between the

battery contacts.

Close case and re-install screw.

Note: There is no need to re-enroll the V- KeyFobs after a battery change.

I

II

Press [

I] and [II]

simultaneously to trigger

 panic alarm

• 

Press [

II ] for:

• 

Hold down [

II]

for 2 sec. for:

• 

Press [

I] to

Arm or Disarm
system.

• 

Hold down [

I]

for 2 seconds
to arm in Stay
Mode

Each Keyfob used on the system must be enrolled into the receiver using the following
procedure:

Press Enroll Mode Push Button in lower
left hand corner of receiver. (see below)

The Enroll  Mode LED will begin
pulsing rapidly.

Press button [

I] on the KeyFob to be

enrolled.

The LED will light, and then begin
pulsing again.

If only one KeyFob is to be enrolled,
press the Enroll  Mode Push Button to
exit program mode.

The LED will go out.

Press button [

I] on second KeyFob to be

enrolled.

The LED will light and then go out,
automatically exiting Enroll Mode.

• 

A maximum of 2 KeyFobs may be enrolled.

• 

I

f a second KeyFob is to be added to an existing

system, both KeyFobs must be re-enrolled.

• 

To remove a lost KeyFob from the system, press the
Enroll button and then press again to exit the Enroll
Mode. All keyfobs will be deleted from the system.

Enroll

Mode

LED

Enroll Mode

Push Button