ICOM 357000 Benutzerhandbuch
8
3
PREPARATION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
MMSI code programming
N
The 9 digit MMSI (Maritime Mobile Service Identity: DSC self
ID) code can be programmed at power ON.
ID) code can be programmed at power ON.
This initial code setting can be performed only once.
After being set, it can be changed by only your dealer
or distributor. If your MMSI code has already been pro-
grammed, this programming is not necessary.
or distributor. If your MMSI code has already been pro-
grammed, this programming is not necessary.
Hold down [PWR](Dial) to turn ON the power.
q
s
Push [ENT] to start the MMSI code programming.
w
s
normal operating screen. In this case, the transceiver cannot
make a DSC call. To program the MMSI code, turn OFF the
power, then turn it ON again.
make a DSC call. To program the MMSI code, turn OFF the
power, then turn it ON again.
Enter your MMSI code in the following manner:
e
s
∫]/[√]/[Ω]/[≈].
s
s
←” or “→,” then push
[ENT] or Dial.
Repeat step
r
e to enter all 9 digits.
After entering the 9 digit code, “FINISH” is automatically
t
selected, and then push [ENT] or Dial to set it.
The “MMSI CONFIRMATION” screen is displayed.
The “MMSI CONFIRMATION” screen is displayed.
y
Enter your MMSI code again for confirmation.
u
s
e through t.
When your MMSI code programming is successfully com-
i
pleted, the screen as shown below is briefly displayed.
s
The programmed MMSI code can be checked in the MENU
screen. (p. 92)
screen. (p. 92)