Aputure Imaging Industries Co. Ltd 2N-BLK Benutzerhandbuch

Power exhausting prompt design 

Transmitter: 

Slide the battery-chamber cover from the back 

of the transmitter and insert one 12V/23A 

battery  

(enclosed in package). 

 

Receiver: 

Slide the battery-chamber cover   

from the back of the receiver and 

insert two AAA 1.5v alkaline   

batteries  

(enclosed in package). 

 

When replacing batteries on transmitter or receiver: 

1. Check the receiver is on the (off ) position 

2. Turn the camera off and disconnect the receiver 

3. Remove the batteries. 

 

The Low Battery Indicator: 

LED indicator on receiver blinking fast when the batteries are low, ready change batteries. 

1、Turn off the camera and set the switch(5) of the receiver to  ｀off＇. 

2、Insert the cable end camera plugin (13) into camera remote socket, cable end receiver plugin 

(12) into receiver plugin socket (3). 

3、

Adjust radio channel (2) on receiver and transmitter to the same position, e.g. the channel on the 

receiver set to  ｀1234  ＇and the transmitter must use the same channel. 

4、Set the receiver switch (5) to  ｀on＇, and turn on the camera. 

5、Extend the transmitter antenna (11) fully. 

 

A. Single shutter (camera in single shoot) 

Half press the release button on transmitter for activating camera’s auto focus and light metering 

system. Full press release button for picture shooting. LED indicator turns from green to red. 

 

B. Continuous shutter (camera in continuous shoot) Same step as single, but keep the release 

button for taking picture continually. 

 

C. Bulb shutter (camera in bulb) 

same step as single shutter while hold release button over 3 seconds, free to loose release button