Visiplex Inc. VTX1 Benutzerhandbuch

Version: 1.00

 

VTX-1 Radio Transceiver - User Manual 

 
The VTX-1 radio transceiver is designed to receive and transmit wireless analog & digital data and is designed to be used in 
VISIPLEX products (such as paging encoders, data repeaters, wireless intercom controllers, etc.). The VTX-1 is typically 
mounted inside the VISIPLEX host product and connected to its controller board using the Data & Power Interface 8-pin 
cable. The VTX-1 unit is fully contained and no external adjustments are provided. 
 
Programming of the VTX-1 parameters is performed via the USB port using commands sent via the PC serial port to the 
VTX-1 host controller. The serial commands are sent using serial communication utilities such as HyperTerminal. 
After programming is completed and the VTX-1 is mounted in to the VISIPLEX product, the USB port is not accessible to the 
typical end user. 
 
Note: The programming commands are available only to in-house radio technicians or external radio professionals familiar 
with FCC restrictions under KDB 594280 to ensure compliance with FCC regulations. 
 
 

Licensing 

 
Some frequency bands governed by FCC rules require that the radio owner obtain a station license before using the 
equipment to transmit. The station license holder is also responsible for the proper operation and maintenance of the VTX-1. 
 
Note: The host end product label must include the following text: "Contains FCC ID: 2AAFWVTX1" 
 
 

Safety 

 
Please refer to RF Radiation Hazard Warning under Notice to User Regarding Radio Frequency Interference section for 
information regarding RF radiation and recommended operation guidelines.