Mansion Industry Co Ltd 1500491T Benutzerhandbuch
THE PERFORMANCE YOU NEED
®
®
Wireless Subwoofer Kit
User’s Guide
1500492
Please read this user’s guide before using your new
subwoofer kit.
2
2
3
3
4
4
5
5
6
6
7
7
8
8
Use Your Subwoofer Kit
When connected, the transmitter
and the receiver LEDs flash green
and blue. When the audio source is
active, the speakers automatically
activate, and the LEDs light blue.
n
Note:
After powering on,
if there is no signal input, the
subwoofer kit enters standby mode.
Optimize Your Surround Sound
Many surround-sound systems let you adjust the delay
between the front and rear speakers. To optimize your
setup, adjust the rear speaker delay response by about 20
milliseconds.
Change the Channel
If you experience any interference,
press and hold the M button on both
units. The units will automatically
match up.
FCC Information
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
If you cannot eliminate the interference, the FCC requires that you stop
using your product. Changes or modifications not expressly by the party
responsible for compliance could void the user’s authority to operate the
equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful interfer-
ence, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Limited Warranty
Ignition L.P. warrants this product against defects in materials and work-
manship under normal use by the original purchaser for ninety (90) days
after the date of purchase. IGNITION L.P. MAKES NO OTHER EXPRESS
WARRANTIES.
This warranty does not cover: (a) damage or failure caused by or attributable
This warranty does not cover: (a) damage or failure caused by or attributable
to abuse, misuse, failure to follow instructions, improper installation or
maintenance, alteration, accident, Acts of God (such as floods or lightning),
or excess voltage or current; (b) improper or incorrectly performed repairs by
persons who are not a Ignition L.P. Authorized Service Facility; (c) consum-
ables such as fuses or batteries; (d) ordinary wear and tear or cosmetic
damage; (e) transportation, shipping or insurance costs; (f) costs of product
removal, installation, set-up service, adjustment or reinstallation; and (g)
claims by persons other than the original purchaser.
Should a problem occur that is covered by this warranty, take the product and
the sales receipt as proof of purchase date to the place of purchase. Ignition
L.P. will, at its option, unless otherwise provided by law: (a) repair the product
without charge for parts and labor; (b) replace the product with the same or
a comparable product; or (c) refund the purchase price. All replaced parts and
products, and products on which a refund is made, become the property of
Ignition L.P. New or reconditioned parts and products may be used in the
performance of warranty service. Repaired or replaced parts and products
are warranted for the remainder of the original warranty period. You will be
charged for repair or replacement of the product made after the expiration of
the warranty period.
IGNITION L.P. EXPRESSLY DISCLAIMS ALL WARRANTIES AND CONDI-
IGNITION L.P. EXPRESSLY DISCLAIMS ALL WARRANTIES AND CONDI-
TIONS NOT STATED IN THIS LIMITED WARRANTY. ANY IMPLIED
WARRANTIES THAT MAY BE IMPOSED BY LAW, INCLUDING THE IMPLIED
WARRANTY OF MERCHANTABILITY AND, IF APPLICABLE, THE IMPLIED
WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE, SHALL EXPIRE
ON THE EXPIRATION OF THE STATED WARRANTY PERIOD.
EXCEPT AS DESCRIBED ABOVE, IGNITION L.P. SHALL HAVE NO LIABILITY
EXCEPT AS DESCRIBED ABOVE, IGNITION L.P. SHALL HAVE NO LIABILITY
OR RESPONSIBILITY TO THE PURCHASER OF THE PRODUCT OR ANY
OTHER PERSON OR ENTITY WITH RESPECT TO ANY LIABILITY, LOSS
OR DAMAGE CAUSED DIRECTLY OR INDIRECTLY BY USE OR PERFOR-
MANCE OF THE PRODUCT OR ARISING OUT OF ANY BREACH OF THIS
WARRANTY, INCLUDING, BUT NOT LIMITED TO, ANY DAMAGES RESULT-
ING FROM INCONVENIENCE AND ANY LOSS OF TIME, DATA, PROPERTY,
REVENUE, OR PROFIT AND ANY INDIRECT, SPECIAL, INCIDENTAL, OR
CONSEQUENTIAL DAMAGES, EVEN IF IGNITION L.P. HAS BEEN ADVISED
OF THE POSSIBILITY OF SUCH DAMAGES.
Some states do not allow limitations on how long an implied warranty lasts
Some states do not allow limitations on how long an implied warranty lasts
or the exclusion or limitation of incidental or consequential damages, so the
above limitations or exclusions may not apply to you. This warranty gives
you specific legal rights, and you may also have other rights which vary from
state to state. You may contact Ignition L.P. at:
Ignition L.P.
Ignition L.P.
3102 Maple Ave.Suite 450
Dallas, TX 75201
02/09
For product support, call
1-866-315-0426
Printed
in China
08A13
1500492
Complies with the European Union’s “Restriction of
Hazardous Substances Directive,” which protects the
environment by restricting specific hazardous materials
and products.
© 2013. Ignition L.P. All rights reserved. Auvio is a registered
trademark used by Ignition L.P.
Package and user documentation are recyclable. User
Package and user documentation are recyclable. User
documentation contains recycled material.
Package Contents
Transmitter
D
Receiver
9V AC Adapter (2)
D
User’s Guide
Features
2.4GHz digital wireless link provides crystal clear
audio.
34-channel selection.
Up to 100 feet (30.5m) operation distance
between transmitter and receiver (line of sight).
Specifications
Audio Output Level ...........................................................2 V
Frequency Response ........................................20-20,000Hz
Audio Distortion .............................................................<1%
Signal to Noise Ratio ...................................................>80dB
Specifications are subject to change and improvement
Frequency Response ........................................20-20,000Hz
Audio Distortion .............................................................<1%
Signal to Noise Ratio ...................................................>80dB
Specifications are subject to change and improvement
without notice. Actual product may vary from the images
found in this document.
Set up the Transmitter and Receiver
Place the transmitter and receiver within 100 feet of each
other, on a flat surface or mounted on a wall.
1.
With the audio source off, connect the transmitter to
the subwoofer jack with an RCA cable (not included).
2.
Connect the supplied AC adapter (9V, 200mA) to the
transmitter DC IN 9V jack, and then plug it into a
standard household outlet.
3.
Connect the receiver to your subwoofer with an RCA
cable (not included).
4.
Connect the supplied AC adapter (9V, 200 mA) to the
receiver DC IN 9V jack, and then plug it into a standard
household outlet.
n
Note:
Use only the supplied AC adapters. Using adapters not
designed for this product may cause damage.
If you mount the receiver on a wall, do not block the
ventilation slots.
Unplug the AC adapters from the AC outlet before
disconnecting from the transmitter or receiver.
- OR -
LED Indicator
1500492_PM_EN.indd 1-8
8/21/2013 5:23:49 PM